Manual Karcher HGE 18-45 Battery (page 16 of 212) (All languages)

725000

Zoom out

Zoom in

1/212

16 English

Remove the battery pack from the device before trans-

port.

Store the hedge trimmer only with the blade guard fitted.

The device may only be stored indoors.

Care and service

몇 CAUTION

Uncontrolled startup

Incision injuries

Remove the battery from the device before all work on

the device.

몇 CAUTION

Risk of injury from sharp blades

Wear safety goggles and protective gloves when work-

ing on the device.

Cleaning the device

ATTENTION

Incorrect cleaning

Damage to the device

Clean the device with a damp cloth.

Do not use solvent-based cleaning agents.

Do not immerse the device in water.

Do not clean the device with a hose or high-pressure

water jet.

Illustration F

1. Allow the device to cool down.

2. Remove plant residue and dirt from the blade and

motor casing with a brush.

3. Clean the ventilation slits on the device with a brush.

Checking the blade screw connection

몇 CAUTION

Loose screw connections

Incision injuries through uncontrolled blade movements

Check the screw connection of the blade regularly to en-

sure it is firmly fastened.

Illustration G

1. Check that all screws/nuts are tight.

2. Tighten any loose screws/nuts.

Oiling the blade sections

In order to maintain the blade quality, the blade sections

should be oiled after each use.

Note

Using thin machine oil or spray oil will yield very good

results.

Illustration H

1. Place the device on a flat surface.

2. Apply oil to the top of the blade sections.

Sharpening the blade sections

Note

Remove as little material as possible during sharpening

and maintain the original angle of the blade tooth in the

process.

몇 CAUTION

Sharp blade

Incision injuries

Wear suitable protective gloves when sharpening the

blade sections.

1. Clamp the blade in a vice.

2. Sharpen the exposed side of the blade teeth with a

file.

3. Carefully push the blade further by hand so that the

unsharpened blade teeth are accessible.

4. Sharpen the exposed side of all blade teeth with a

file.

Troubleshooting guide

Malfunctions often have simple causes that you can

remedy yourself using the following overview. When in

doubt, or in the case of malfunctions not mentioned

here, please contact your authorised Customer Service.

As the battery pack ages, even if it is looked after, its ca-

pacity reduces such that the full run time will no longer

be reached when fully charged. This does not indicate a

defect.

Warranty

The warranty conditions issued by our relevant sales

company apply in all countries. We shall remedy possi-

ble malfunctions on your appliance within the warranty

period free of cost, provided that a material or manufac-

turing defect is the cause. In a warranty case, please

contact your dealer (with the purchase receipt) or the

next authorised customer service site.

(See overleaf for the address)

Technical data

Fault Cause Rectification

The device does not start

Battery pack is not inserted correctly.  Push the battery pack into the mounting

until it latches into place.

Battery pack is empty  Charge the battery pack.

Battery pack is defective.  Replace the battery pack.

The device stops during

operation

Blade blocked with cutting material.  Remove cutting material from the blade.

The battery has overheated  Stop working and allow the battery to cool

down to normal battery temperature.

Motor has overheated  Stop working and allow the motor to cool

down.

HGE 18-

Device performance data

Working voltage of the battery V 18

Idling speed (normal setting) /min 1500

Cut material diameter (max.) mm 18

How easy is it to remove cut bar from this tool
I’m taking it on a plane needs to fit in a suitcase Submitted on 2-11-2020 at 00:16
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Karcher HGE 18-45 Battery in the language / languages: All languages as an attachment in your email.

The manual is 18,97 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Karcher HGE 18-45 Battery Manual

Product: