Manual Karcher HDS 9-16-4 ST Gas (page 32 of 548) (All languages)

726286

Zoom out

Zoom in

1/548

- 10

You can enter into a maintenance contract with the concerned

Kaercher Sales Office for the machine.

Figure 1 - Pos. 3

Shut off water supply.

Remove the water inlet hose on the appliance.

Push out the sieve from the connection using a screw-driver.

Cleaning the sieve

Assemble it back in the reverse sequence.

Remove covering panels.

Unscrew the bracket from the safety block.

Turn in screw M8x30 into the sieve.

Pull out the screw and the sieve using pliers.

Cleaning the sieve

Assemble it back in the reverse sequence.

When there are deposits formed in the pipe connections, there is

an increase in the flow resistance; this can cause the pressure

switch to be triggered.

DANGER

Risk of explosion due to combustible gases! Smoking strictly pro-

hibited during decalcification. Ensure proper ventilation.

DANGER

Risk of chemical burns on account of acid! Wear protective glass-

es and protective gloves.

According to statutory requirements, only tested and approved

boiler decrusting agents may be used.

– RM 100 (Order No. 6.287-008) dissolves chalk and simple

compounds of chalk and detergents residues.

– RM 101 (Order No. 6.287-013) dissolves the deposits that

cannot be dissolved using RM 100.

Fill a 20 litre container with 15 l water.

Add one litre of boiler decrusting agent.

Connect the water hose directly to the pump and hang in the

other free end into the container.

Insert the connected spray pipe without nozzle into the con-

tainer.

Open the hand-spray gun and do not close it during the de-

calcification process.

Switch on the appliance switch to "Burner on" until the tem-

perature of approx. 40 °C is reached.

Switch off the appliance and let it stand for 20 minutes. The

hand-spray gun must remain opened.

Then pump out the machine until empty.

Note: As an anti-corrosion measure and for neutralising the acid

residue, we recommend that you finally pump an alkaline solution

through the machine (for e.g. RM 81) via the detergent tank.

The machine should be stored in frost-free rooms. In case there

is frosting risk, for e.g. if the machine is installed in open areas,

then the machine must first be emptied and flushed using an anti-

freezing agent.

Screw off water supply hose and high pressure hose.

Operate device for max. 1 minute until the pump and conduits

are empty.

Screw off supply hose at boiler bottom and drain heating spi-

ral empty.

Note: Observe handling instructions of the anti-freeze agent

manufacturer.

Fill in normal anti-frost agents in the swimmer tank right until

the top.

Place the collection trough under the high pressure exit.

Switch on the appliance and let it run until the safety mecha-

nism against lack of water in swimmer tank gets activated and

the machine is switched off.

Fill the boiler floor and siphon with anti-frost agent.

A certain corrosion protection is achieved with this as well.

Maintenance contract

Cleaning the sieve

Sieve in water inlet

Sieve in the water shortage safe guard

Descaling

Performance

Frost protection

Drain water

Flush device with anti-freeze agent

32 EN

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Karcher HDS 9-16-4 ST Gas in the language / languages: All languages as an attachment in your email.

The manual is 31,04 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Karcher HDS 9-16-4 ST Gas Manual

Product: