726238
33
Zoom out
Zoom in
Previous page
1/512
Next page
- 13
DANGER
Before carrying out any tasks on the ma-
chine, switch the key switch off and remove
it.
DANGER
Risk of injury on account of electric shock!
Do not place metallic objects on the alter-
nator or starter.
DANGER
Risk of explosion! Do not put tools or similar
on the battery, i.e. on the terminal poles
and cell connectors.
Allow device to cool down.
Disassemble the water inlet filter and
take out the filter inlay.
Clean the filter with clean water or com-
pressed air.
Reinstall in reverse sequence.
Unpressurize the appliance.
Disassemble the pump prefilter and
take out the filter inlay.
Clean the filter with clean water or com-
pressed air.
Reinstall in reverse sequence.
Unscrew the screw cap of the detergent
suction hose.
Take out detergent suck hose.
Clean filter in water and reinstall.
Note: The filling quantity between the MIN
and MAX markings on the oil dipstick is 1.6
litres.
Remove the oil dip, wipe it and reinsert
it.
Remove the oil dip one more time and
check the oil level.
The oil level is correct if it is within the
markings on the oil dip.
If the oil level is below the mark, open
the filler neck lid and add fresh motor
oil.
Wait five minutes, until the oil has col-
lected in the oil pan.
Check the oil level as described above.
Repeat this procedure as often as nec-
essary until the oil level is between the
markings on the oil dip.
After the check, insert the oil dip and
close the lid of the filler neck.
Note: Air pockets must be able to leak out.
For oil type refer to technical specifica-
tions
Check the oil level at the oil-level gauge
of the intermediate gear.
The oil level is correct if it is in the mid-
dle of the oil-level gauge.
If the oil level is below the middle of the
oil-level gauge, open the lid of the filling
hole and fill in fresh transmission oil.
Close filling hole.
Note: Air pockets must be able to leak out.
For oil type refer to technical specifica-
tions
HDS 9/50, HDS 13/35 only:
Check the oil level at the oil tank of the
high-pressure pump.
The oil level is correct if it is between the
MIN and MAX marking.
If the oil level is below the MIN marking,
open the lid of the oil container and fill in
fresh oil.
Close the lid of the oil container.
Note: Air pockets must be able to leak out.
For oil type refer to technical specifica-
tions
HDS 13/20, HDS 17/20 only:
Remove the oil dipstick, wipe it and in-
sert it again.
Remove the oil dipstick again and
check the oil level.
The oil level is correct if it is within the
markings on the oil dip.
If the oil level is below the mark on the
oil dipstick, fill up with fresh oil.
Twist in the oil dipstick.
Note: Air pockets must be able to leak out.
For oil type refer to technical specifica-
tions
CAUTION
Observe the brand of antifreeze used. The
mixture can cause a chemical reaction and
hazardous substances can be generated.
Do not mix different antifreeze types.
WARNING
The motor can overheat if there is a lack of
coolant. Turn the motor off immediately and
let it cool down.
WARNING
If the motor is so overheated, that water va-
pors escape, immediately turn the motor off
and keep a safety distance to the motor un-
til the pressure has decreased.
WARNING
Scalding danger! Never open the lid on the
expansion tank of the motor cooling water
with operating temperature. The container
is under pressure.
Open the lid on the equalisation con-
tainer of the motor coolant, fill in fresh
clean water and the required antifreeze.
Note: For rough cleaning of the air filter,
proceed as follows: Hold the catch pan un-
der the dirt outlet and operate the dirt outlet.
Note: Heavily soiled or defective filter in-
lays must always be replaced.
Loosen the spring tension bracket, re-
move the cover and eliminate the dust
deposits.
Take out the filter inlay.
Blow out the filter insert with com-
pressed air (max. 2 bar) from the inside.
Clean the inside of the air filter housing
with a cloth.
Insert the filter inlay into the air filter
casing.
Attach the cover and fasten it by means
of the spring tension bracket.
Maintenance Works
Clean the water inlet filter
Clean the pump prefilter
Clean filter at the detergent suck hose
Check the oil level on the motor and add
motor oil
Checking the oil level on the
intermediate gear and refilling
transmission oil
Check the oil level on the oil tank of the
high-pressure pump, then top up the oil
if necessary
Check the oil level on the oil dipstick of
the high-pressure pump, then top up the
oil if necessary
Check the coolant and refill
Cleaning/replacing the air filter
33EN
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher HDS 13-20 De Tr1 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher HDS 13-20 De Tr1 in the language / languages: All languages as an attachment in your email.

The manual is 111,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info