726290
33
Zoom out
Zoom in
Previous page
1/524
Next page
- 12
Fault Possible cause Remedy of whom
Indicator lamp for protection
against calcification (H) glows
The softener is over. Refill the softener. Operator
Inadequate or no flow of de-
tergent
Dosing valve to position "0". Adjusting the detergent metering valve. Operator
Detergent filter blocked or tank is
empty.
Clean and/or refill. Operator
Detergent suction hoses, detergent
metering valve or detergent sole-
noid valve are leaky or blocked.
Check, clean. Operator
Electronics or solenoid valve is de-
fective.
Replace Customer Service
Full pressure does not build
up in the appliance
Flushed the nozzle. Replace the nozzle. Operator
Detergent tank is empty. Refill detergent. Operator
Not enough water Ensure adequate water supply. Operator
Sieve at the water inlet is blocked. Check, dismantle sieve and clean it. Operator
Leaky detergent dosing valve. Check and seal it. Operator
Leaky detergent hoses. Replace Operator
Swimmer valve is jammed. Check and ensure that it moves freely. Operator
Safety valve is leaky. Check the setting; install new washers, if re-
quired.
Customer Service
Flow valve is leaky or has been set
at a low value.
Check valve parts; replace damaged parts;
clean the dirt.
Customer Service
Solenoid valve for pressure release
is defective.
Replace solenoid valve. Customer Service
High pressure pump is knock-
ing; manometer is swaying
wildly
Vibration dampener is defective. Replace vibration dampener. Customer Service
Water pump does not suck in ade-
quate air.
Check suction system and remove leaks. Operator
Device continuously turns on
and off while hand spray gun
is open
Nozzle in spray pipe is blocked. Check, clean. Operator
Appliance is decalcified. See section "Descaling". Operator
Switching point of the over-current
monitor has got shifted.
Get somebody to reset the over-current mon-
itor.
Customer Service
Sieve blocked in the water shortage
safe guard.
Check, dismantle sieve and clean it. Operator
Appliance does not switch off
when the hand-spray gun is
closed
The pump has not been fully vent-
ed.
Set the machine switch to "0" and pull the
hand-spray gun until no fluid comes out of the
nozzle. Turn on the appliance again. Repeat
this procedure until the full operating pressure
is reached.
Operator
Safety valve or safety valve washer
is defective.
Replace the safety valve and/or the washer. Customer Service
33EN
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher HDS 12-14-4 ST at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher HDS 12-14-4 ST in the language / languages: All languages as an attachment in your email.

The manual is 17,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info