538578
33
Zoom out
Zoom in
Previous page
1/484
Next page
– 10
Fuel tank empty
Refill.
Engine overload/overheat
Turn device switch on "0" and let engine
cool off for min. 5 minutes.
If malfunction still occurs, have device
checked by customer service.
No line voltage, see "Appliance is not
running".
Liquid softener tank is empty, due to
technical reasons a remainder stays in
the tank.
Refill.
Electrodes in the tank are dirty
Clean the electrodes.
Set the appliance switch to "0".
Allow device to cool down.
Set the appliance switch to "I".
No power
Check power connection/conduit.
Air within the system
Vent pump:
Set dosing value for detergent to "0".
With open hand spray gun turn device
on and off multiple times with the device
switch.
Close and open the regulating spingle
(figure 9) with open hand spray gun.
Note: By dismantling the high pressure
hose from the high pressure connection the
venting process is accelerated.
If detergent tank is empty, refill.
Check connections and conduits.
Pressure is set to MIN
Set pressure to MAX.
Sieve in the water connection is dirty
Clean sieve.
Clean the fine filter; replace it, if neces-
sary.
Amount of water supply is too low.
Check water supply level (refer to tech-
nical data).
Pump leaky
Note: 3 drops/minute are allowed.
With stronger leak, have device
checked by customer service.
Leak in the high pressure system
Check high pressure system and con-
nections for tightness.
Leave device running with open deter-
gent dosage valve and closed water
supply, until the swimmer tank is
sucked empty and the pressure falls to
"0".
Open the water supply again.
If the pump still is not sucking in any deter-
gent, it could be because of the following
reasons:
Filter in the detergent suck hose dirty
Clean filter.
Backflow valve stuck
Figure 15
Remove the detergent hose and loosen
the backflow valve using a blunt object.
Fuel tank empty
Refill.
Water shortage
Check water supply, check connec-
tions, clean water shortage safeguard.
Fuel filter dirty
Change fuel filter.
Fuel indicator lamp glows
Indicator lamp "Ready for use"
turns off
Indicator lamp liquid softener glows
Engine control lamp glows
Appliance is not running
Device is not building up pressure
Device leaks, water drips from the
bottom of the device
Device turns on and off while hand
spray gun is closed
Device is not sucking in detergent
Burner does not start
33EN
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher HDS 1195 SX Eco at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher HDS 1195 SX Eco in the language / languages: All languages as an attachment in your email.

The manual is 5,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Karcher HDS 1195 SX Eco

Karcher HDS 1195 SX Eco User Manual - Dutch - 25 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info