726230
23
Zoom out
Zoom in
Previous page
1/428
Next page
– 4
Check the high-pressure hose daily.
Do not use hoses with kinks.
Stop using the high-pressure hose if the
external wire layer is visible.
Do not use the high-pressure hose any-
more if the winding is damaged.
Lay the high-pressure hoses in such a
way that no vehicle can drive over it.
Do not use high-pressure hoses that
have been driven over, kinked, pressed
or bent even if there is no externally vis-
ible damage.
Store the high-pressure hoses in such a
way that they are not subject to any me-
chanical load.
Safety devices serve for the protection of the
user and must not be put out of operation or
bypassed with respect to their function.
The safety mechanism against lack of water
prevents the heater from over-heating when
there is no water. The burner operates only
when there is adequate water supply.
If the hand spray gun is closed, the
overflow valve opens and the high pres-
sure pump diverts the water back to the
pump suction side. Thus the permissi-
ble working pressure is not exceeded.
The overflow valve is set by the manu-
facturer and sealed. Setting only by
customer service.
The safety valve opens when the over-
flow valve is defective.
The safety valve is set by the manufac-
turer and sealed. Setting only by cus-
tomer service.
The pressure switch switches off the burner
when the working pressure falls below the
minimum value and switches it on again
when it is exceeded.
The safety catch on the trigger gun pre-
vents the appliance from being switched on
unintentionally.
WARNING
Risk of injury! Appliance, accessories, sup-
ply lines and connections must be in fault-
free condition. If they are not in a perfect
state then the appliance must not be used.
Attach both spray lance rests before in-
itial startup (see figure A at the begin-
ning of these instructions).
ATTENTION
Risk of damage! In case of lacteous oil inform
Kärcher customer service immediately.
Check oil level of the high pressure
pump at the oil sight glass.
Do not operate the appliance if the oil level
has fallen below "MIN".
Add oil if required (see technical speci-
fications).
Follow the instructions given in the sec-
tion "Safety Notes"!
Read the operating instructions of the
engine manufacturer before start-up
and follow the safety instructions care-
fully.
Check air filter.
Check oil level of the engine.
Do not operate the appliance if the oil level
has fallen below "MIN".
If required, top up oil carefully.
Fill the fuel tank with unleaded petrol.
Do not use 2-speed mixture.
Fill fuel tank with diesel.
Safety Devices
Water shortage safeguard
Overflow valve
Safety valve
Pressure switch
Safety catch
Start up
Attaching the spray lance rest
Check oil level of the high pressure
pump
Motor
HDS 1000 BE:
HDS 1000 DE:
23EN
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher HDS 1000 BE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher HDS 1000 BE in the language / languages: All languages as an attachment in your email.

The manual is 5,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info