478154
13
Zoom out
Zoom in
Previous page
1/123
Next page
13
5.956-722 English
6. In the event of malfunction
The brush and suction motor is switched off via the built-in
electronic system
Brush is blocked
Withdraw mains plug, check brush for any dirt and if
necessary remove the blockage. The unit now has to be
restarted.
Suction turbine switches off, brush head carries on
functioning
(red indicator light goes off)
Thermal switch has disengaged motor due to overheating
Withdraw mains plug, exchange blocked filter or eliminate
suction hose blockage. After approximately 20 minutes, the
unit will start up again.
Suction hose is blocked
Switch off the unit. Remove the flexible hose from the housing and
pull it straight. Use something long to release hose blockage.
The suction hose can be disconnected from the unit by
pressing the locking lever. <Figure 11>
Connecting hose is blocked
The connecting hose can be removed by pulling out both
ends. Remove the blockage. <Figure 12>
Connection cable not inserted properly
Connect the upper section of the vacuum cleaner to the brush
head. Connect the hose to the brush head and upper section
of vacuum cleaner. Plug the connecting cable with connector
into the socket on the upper section (plug must audibly click into
place). <Figure 13>
Brushes in brush head are not rotating, suction turbine is
running
Hand pipe is not pushed into motor housing properly, or end is
worn down
If the end of the pipe has been worn down (due to vacuuming
without first fitting the crevice or upholstery nozzle), the end
switch will not be actuated and the brushes will not rotate.
Separating the brush head from the upper section of the
vacuum cleaner
Undo the connecting cable, release the plug by pressing in a
pointed object (e.g. screwdriver). <Figure 14>
The connecting hose can be removed by pulling out the two
ends.
Undo both screws at the side of the upper section to the
vacuum cleaner.
Figure 11
Figure 12
Figure 14
Figure 13
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher CW50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher CW50 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Turkish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 5,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info