725100
22
Zoom out
Zoom in
Previous page
1/344
Next page
22 English
period of use cannot be set, because this depends on
several influencing factors:
Personal tendency to suffer from poor circulation
(frequently cold fingers, tingling sensation in the fin-
gers)
Low ambient temperature. Wear warm gloves to
protect your hands.
Holding the device too tightly hindering blood circu-
lation.
Continuous operation is more harmful than opera-
tion interrupted by work breaks.
You should see a doctor if using the device regularly
and for lengthy periods of time, and in the event of re-
peated occurrences of symptoms such as tingling in
the fingers or cold fingers.
Intended use
DANGER
Improper use
Danger of death from incision injuries
Only use the device for its proper use.
The chainsaw is only intended for private use.
The chainsaw is intended for outdoor use.
For safety reasons, always hold the chainsaw firmly
with both hands.
The chainsaw was developed for sawing small
branches, large branches, trunks and beams. The
cutting length of the guide rail determines the maxi-
mum possible diameter of the sawed material.
The chainsaw may only be used for cutting wood.
Do not use the chainsaw in a wet environment or in
the rain.
Use the chainsaw only in a well lit environment.
Modifications and changes to the device that are not
authorised by the manufacturer are prohibited for
safety reasons.
Any other use is prohibited. The user shall be liable for
hazards arising as a result of improper use.
Environmental protection
The packing materials can be recycled. Please
dispose of packaging in accordance with the en-
vironmental regulations.
Electrical and electronic appliances contain valu-
able, recyclable materials and often components
such as batteries, rechargeable batteries or oil,
which - if handled or disposed of incorrectly - can
pose a potential threat to human health and the environ-
ment. However, these components are required for the
correct operation of the appliance. Appliances marked
by this symbol are not allowed to be disposed of togeth-
er with the household rubbish.
Notes on the content materials (REACH)
Current information on content materials can be found
at: www.kaercher.com/REACH
Accessories and spare parts
Only use original accessories and original spare parts.
They ensure that the appliance will run fault-free and
safely.
Information on accessories and spare parts can be
found at www.kaercher.com.
Scope of delivery
The scope of delivery for the appliance is shown on the
packaging. Check the contents for completeness when
unpacking. If any accessories are missing or in the
event of any shipping damage, please notify your deal-
er.
Safety devices
CAUTION
Missing or modified safety devices
Safety devices are provided for your own protection.
Never modify or bypass safety devices.
Chain with a low risk of kickback
A chain with a low risk of kickback reduces the likelihood
of kickback.
The raked teeth (engagement blades) in front of each
saw tooth prevent the saw teeth from engaging too
deeply in the kickback zone, thus reducing the amount
of kickback.
When grinding the chain, there is a danger that this
safety function will be overridden. If the saw perfor-
mance deteriorates, the chain should be replaced for
safety reasons. For spare parts, use only the combina-
tion of guide rail and chain recommended by the manu-
facturer.
Guide rails
Guide rails whose tips have a small radius usually carry
a lower risk of kickback.
Therefore use a guide rail with matching chain for the
task, which is just long enough. Longer guide rails in-
crease the likelihood of loss of control during sawing.
Check the chain tension before each use (see chapter
Checking the chain tension). If the chain tension is not
set correctly, sawing smaller branches (thinner than the
full length of the guide rail) increases the danger of the
chain being thrown off.
Chain catcher
If the chain loosens or tears, the chain catcher prevents
the chain from being thrown in the direction of the user.
Bucking spikes
The integrated bucking spikes can be used as a fulcrum
to give the chain saw stability during a cut.
When sawing, press the device forward until the metal
spikes penetrate the edge of the wood. Subsequently
moving the rear handle up or down in the direction of the
cut reduces the physical strain when working with the
chainsaw.
Chain brake
Chain brakes are used in case of danger to bring the
chain quickly to a standstill.
The chain must come to a standstill immediately when
the hand guard/chain brake lever is pressed in the direc-
tion of the guide rail.
The chain brake cannot prevent kickback, but reduces
the risk of injury if the guide rail hits the user in the event
of a kickback.
The proper function of the chain brake must be checked
before each use of the device (see chapter Checking
the functionality of the chain brake).
Symbols on the device
General warning symbol
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher CNS 36-35 Battery at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher CNS 36-35 Battery in the language / languages: All languages as an attachment in your email.

The manual is 42,2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info