804742
16
Zoom out
Zoom in
Previous page
1/236
Next page
– 6
WARNING
Risk of injury if the machine is left running
in an unattended state.
Turn the appliance off and remove the bat-
tery before carrying out any tasks on the
machine.
ATTENTION
Risk of damage to the device on account of
water leakage. Empty the waste water tank
and the fresh water tank prior to performing
maintenance tasks on the device.
In case of faults that cannot be remedied
using the table below please contact the
customer service.
Faults
Fault Remedy
Appliance is not running Check if there is a sufficiently charged battery in the compart-
ment and make sure it is inserted up to the stop and snapped
in place.
Check if foreign matters are blocking the brush roller; remove
foreign matter if required.
Insufficient water quantity Check fresh water level, refill tank if necessary.
Open the lock of the fresh water reservoir. If a vacuum is de-
tected when the tank is opened, clean the ventilation valve in
the lock of the fresh water reservoir.
Clean the water distributor (see chapter "Cleaning the water distributor").
Remove the fresh water tank and check the sieve for contami-
nation. If necessary, remove the sieve and clean it.
Illustration
Pull the valve with the filter off the fresh water tank and rinse it
in lukewarm water.
Clean the sieve in the cleaning head.
Fresh water reservoir drips
when refilled
Illustration
Pull the valve with the filter off the fresh water tank and rinse it
in lukewarm water.
Insufficient vacuum perfor-
mance
Empty the waste water tank.
Lock the waste water reservoir in place on the appliance.
Clean the seals between waste water tank and cover and
check for tightness, replace if required.
Check that all vacuum bars are locked into place in the cleaning head.
Suction bar plugged, clean.
Suction bar worn; exchange the front and rear suctions bars. If
both suction bars are worn, install new suction bars.
Check that both suction tube parts are correctly attached to the
suction tube connection.
Check the suction tube and the suction channel in the cleaning
head for obstruction and remove if necessary (see "Cleaning
suction tube").
Check whether the cable behind the tanks has been routed flat
and whether the included cover is attached.
Insufficient cleaning result Check the brush roller for wear, replace if required.
Brush does not turn Check if foreign matters are blocking the brush roller; remove
foreign matter if required.
Creaking sound, brush
does not turn
Slip clutch was triggered. Switch off the appliance, check/clean
the brush roller.
16 EN
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher BR 30-4 C Bp at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher BR 30-4 C Bp in the language / languages: All languages as an attachment in your email.

The manual is 3.71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info