804751
18
Zoom out
Zoom in
Previous page
1/252
Next page
18 English
1Coarse dirt filter
2. Pull the coarse dirt filter upwards and off.
3. Rinse off the coarse dirt filter under run-
ning water.
4. Reinsert the coarse dirt filter into the
waste water tank.
Cleaning the fresh water filter
1. Drain the fresh water (see Chapter
Draining fresh water).
2. Unscrew the fresh water tank lock.
1Fresh water tank lock
2Fresh water filter
3. Pull out the fresh water filter and rinse
with clean water.
4. Insert the fresh water filter.
5. Fit the fresh water tank lock.
Note: Take care to ensure that the hose
connection in the fresh water tank cap is
positioned at the lowest point in the tank
after screwing the cap in place.
Clean the float and fluff filter
1. Open the waste water tank cover.
1Latching hooks
2Float
3Fluff filter
4Float housing
2. Release the latching hooks.
3. Pull the float housing downwards and
off.
4. Remove the float from the float housing
and clean it.
5. Remove the fluff filter and clean it.
6. Assemble all parts in the reverse order.
Replacing the disc brushes
1. Raise the cleaning head.
2. Press the brush replacement pedal
down, beyond the zone of resistance.
1Brush replacement pedal
3. Pull the 1st disc brush sideways and out
from underneath the cleaning head.
4. Hold the new disc brush under the
cleaning head, then press upwards and
latch it into position.
5. Repeat the procedure for the 2nd disc
brush.
Troubleshooting guide
DANGER
Risk of injury!
The device may start moving unexpectedly
and cause injury.
Turn the key-operated switch to "0" and re-
move the key before performing any work
on the device.
Pull out the charger mains plug.
Drain and dispose of the waste water
and fresh water.
Contact Customer Service in the case of
malfunctions that cannot be corrected
using this table.
Battery status indicator
1Status LED
2Indicator LED 1
3Indicator LED 2
4Indicator LED 3
5Indicator LED 4
6Battery
7Button
1. Press the button for 5 seconds.
No LED lights up: Charge the battery.
The status LED lights up green: To-
gether, all 5 LEDs indicate the battery's
charging state.
The status LED lights up red: The indi-
cator LEDs indicate a malfunction. Mal-
functions described in the following table
can be remedied by the user. Contact
KÄRCHER Customer Service for all
malfunctions indicated not described
above.
1
12
(1) (2) (3) (4) (5) Cause Rectification
red - - - - The battery is too hot. Allow the battery to cool down.
red - - - green The battery management system is
too hot.
Allow the battery to cool down.
red - - green - The battery is too cold for charging. Move the device to a warmer place and wait until the battery
has warmed up.
red - - green green The current consumption during
charging is too high.
Unplug the mains plug of the charger. Wait 10 seconds. Re-
insert the mains plug. If the malfunction is displayed again,
replace the charger.
The current consumption of the de-
vice is too high.
Switch off the device. If the malfunction occurs again after
switching on, look for the fault in the device.
red - green - green Short-circuit. Check all battery connections.
red - green green - Cell voltage too low during dis-
charge.
Charge the battery.
red - green green green Cell voltage too high during charg-
ing.
Discharge the battery to 20% remaining capacity. Then
charge the battery.
red green - - green The battery voltage is too low. Charge the battery.
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher BD 80-100 W at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher BD 80-100 W in the language / languages: All languages as an attachment in your email.

The manual is 141.64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info