804740
13
Zoom out
Zoom in
Previous page
1/244
Next page
- 3
1OFF
Device is switched off
2 Normal mode
Wet clean the floor and vacuum up dirt
water.
3 Intense mode
Wet clean the floor and allow the deter-
gent to react.
4Vacuum mode
Suck in the dirt fleet.
5 Program selection switch
6 Display
** option
Unscrew the screws from the middle
board of the pallet.
Push down the device holding the push
handle and pull out the middle board.
Remove the chocks in front of and next
to the wheels.
Push down the device holding the push
handle and push it forwards up to the
edge of the pallet.
Lift the device off the pallet and set it on
the floor.
Install the batteries (see "Care and Mainte-
nance/Install and connect batteries").
We recommend using our batteries as de-
scribed in chapter "Care and Maintenance/
Recommended batteries".
Note:
The device is equipped with a safety mech-
anism to prevent total discharge, i.e. when
the permissible minimum capacity is
reached, the brush motor and the turbine
are switched off.
Drive the machine directly to the charg-
ing station; avoid any steep gradients in
the process.
DANGER
Danger of injury due to electric shock. Ob-
serve the mains voltage and fuse protec-
tion on the type plate of the device.
Average charging time is approx. 10 -15
hours.
The appliance must not be used during the
charging process.
DANGER
Danger of explosion
Prior to charging low-maintenance bat-
teries
Remove waste water tank (see Chapter
"Maintenance and care/Maintenance
tasks/Removing the waste water tank").
This prevents the accumulation of hazard-
ous gases underneath the tank during the
charging process.
ATTENTION
Risk of damage. Do not clean the device
with water while the tank is removed.
1 Battery plug, appliance side
2 Battery plug, battery side
Detach the battery plug on the unit side.
ATTENTION
Risk of damage!
Do not connect the charger with the
battery plug on the unit side.
Only use a charger that is suitable for
the installed battery type:
Note: Please read the operating instruc-
tions of the charger manufacturer, espe-
cially the chapters on safety instructions!
Connect the battery plug on the battery
side with the charger.
Plug the mains plug of the charger into
a power outlet.
Execute the charging process accord-
ing to the information in the operating
instructions of the charger.
Connect the battery plug on the device
side with the battery plug on the battery
side.
WARNING
Danger of causticization!
Adding water to the battery in its dis-
charged state can cause the acid to
leak.
Use safety glasses while handling bat-
tery acid and follow the safety instruc-
tions to avoid personal injury or damage
to clothes.
Should the acid spray on to the skin or
clothes, rinse immediately with lots of
water.
ATTENTION
Risk of damage!
Use only distilled or desalinated water
(EN 50272-T3) for filling the battery.
Do not add any substances (so-called
performance improving agents), else
warranty claims will not be entertained.
Replace batteries with the same battery
type only.
Insert the vacuum bar into the vacuum
bar suspension in such a manner that
the profiled sheet is positioned above
the suspension.
Tighten the wing nuts.
Insert the suction hose.
Operator console
Symbols on the machine
Battery socket
Lashing point
Mop holder **
Filling level fresh water
tank 25%
Bow brush change
Vacuum bar lowering le-
ver
Drain outlet fresh water
tank
Dirt water discharge
hose
Before Startup
Unloading
Install batteries
Using batteries made by other
manufacturers
Charging battery
Charging process
Battery type Battery set
24 V
Charger
6.654-093.0 4.035-447.0 6.654-329.0
6.654-290.0 4.035-990.0 6.654-332.0
Low maintenance batteries (wet
batteries)
Installing the Vacuum Bar
13EN
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher BD 43-25 C Bp at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher BD 43-25 C Bp in the language / languages: All languages as an attachment in your email.

The manual is 19.2 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info