804757
28
Zoom out
Zoom in
Previous page
1/452
Next page
28 English
Cleaning the fresh water filter
1. Drain the fresh water (see chapter
"Draining fresh water").
2. Unscrew the fresh water tank cap.
1Fresh water filter
2Fresh water tank lock
3. Pull out the fresh water filter and rinse
with clean water.
4. Insert the fresh water filter.
5. Fit the fresh water tank lock.
Note: Take care to ensure that the hose
connection in the fresh water tank cap is
positioned at the lowest point in the tank
after screwing the cap in place.
Cleaning the water distribution strip
1. Press the latch in the direction of the ar-
row and hold it there.
2. Pivot the water distribution strip forward.
3. Pull out the water distribution strip
lengthways.
4. Clean the water distribution strip.
5. Fit the water distribution strip back into
the cleaning head and snap the lock into
place.
Cleaning batteries
1. Wear safety goggles, protective clothing
and protective gloves.
2. Keep the battery cell plugs closed.
3. Remove the batteries.
4. Only clean the plastic parts of the batter-
ies and the battery compartment with
water or water-soaked cleaning cloths
without additives.
5. Dry the surfaces after cleaning.
6. Reinstall the batteries.
Resetting the maintenance counter
If maintenance work shown in the display
has been carried out, the corresponding
maintenance counter must then be reset.
Note
Resetting the maintenance counters is de-
scribed in the chapter "Grey Intelligent Key".
Troubleshooting guide
DANGER
The device can start unintentionally
People working on the device can be injured.
Remove the Intelligent Key prior to all work
on the device.
Before carrying out any work, pull the
mains plug of the internal charger out of the
socket.
Disconnect the battery connector before
performing any work.
1. Drain the waste water.
2. Drain the remaining fresh water.
Note
If the malfunction cannot be remedied with
the following instructions, contact Custom-
er Service.
Malfunctions with information
shown on the display
If the displayed malfunction is not in the fol-
lowing list, do the following:
1. Turn the key-operated switch to "OFF".
2. Wait 10 seconds.
3. Set the program switch to the previous
function.
4. If the malfunction recurs, call Customer
Service.
Malfunction Rectification
fresh water empty 1. Refill the fresh water tank
water valve blocked 1. Set the programme switch to "OFF".
2. Wait 10 seconds.
3. Set the program switch to the desired program.
overload brush head 1. Reduce the contact pressure of the brushes.
blocked main brush 1. Check if the brushes are blocked by a foreign body and remove the foreign body if necessary.
2. Set the programme switch to "OFF".
3. Wait 10 seconds.
4. Set the program switch to the desired program.
overload side brush 1. Reduce the contact pressure of the side scrubbing deck brush.
blocked side brush 1. Check if the brushes are blocked by a foreign body and remove the foreign body if necessary.
2. Set the programme switch to "OFF".
3. Wait 10 seconds.
4. Set the program switch to the desired program.
waste water tank full 1. Empty the waste water tank.
overload drive motor 1. The gradient is too steep.
a In cleaning operation: Cancel cleaning.
b When transporting: Find a path with a lower gradient.
blocked drive motor 1. Check the wheels for blockage, remove foreign objects.
2. Set the programme switch to "OFF".
3. If the engine has overheated, let it cool down for at least 15 minutes, otherwise wait 10 seconds.
4. Set the program switch to the desired program.
battery low 1. Set the program selector switch to TRANSPORT MODE.
2. Drive the device directly to the charger (or with an internal charger to the socket). Avoid gradients.
3. Charge the battery.
battery empty 1. Set the program selector switch to TRANSPORT MODE.
2. Drive the device by the shortest route to the charger (or to the socket in the case of an internal
charger). Avoid gradients.
3. Charge the battery.
seat switch open 1. Relieve the driver's seat briefly so that the control can check the function of the seat contact switch.
switch on! 1. Set the safety switch to "1".
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher B 110 R at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher B 110 R in the language / languages: All languages as an attachment in your email.

The manual is 30.79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info