652992
31
Zoom out
Zoom in
Previous page
1/36
Next page
EN | 31
EN
Radio
There is a power switch (POWER/AL. OFF button) to switch on and off the system.
Power on in tuner mode:
Power-off (clock display):
1. Press Power/AL. off button to turn on the unit.
2. Press RADIO button to select radio.
3. Select AM/FM band by pressing the STOP/BAND button. AM and FM are alternately selected
each time when the STOP/BAND button is pressed.
4. How to use the buttons for radio
a. Manual Tuning
----Higher frequency can be selected by pressing the “SKIP >>|” button
----Lower frequency can be selected by pressing the “SKIP |<<” button
b. Automatic Tuning
----Press and hold the “SKIP >>|” or “SKIP |<<” button until the display frequency starts run.
----When a station of sufcient strength has been found. Tuning will stop or you can stop the
automatic tuning by pressing “SKIP >>|” or “SKIP |<<” button again.
----Repeat until you have found the desired station.
5. Adjust the volume to the desired level. by pressing VOL. UP or VOL. DOWN button.
6. Press the STEREO/MONO button to select Stereo and Mono as desired in case FM band is
being selected. (If stereo signal is too weak , “<<ST>>” icon will not appear, press this button to
mono mode, the reception will be improved)
Note:
For better reception , FM wire antenna shall be fully untied and adjusted well
This unit has a built-in antenna for AM , Locate the unit where you can obtain the best reception.
PRESET TUNING
1. Select the AM/FM band and tune to your desired station according to the normal tuning proce-
dure.
2. Press the MEMORY/C-ADJ button, “P” will appear and ash in the LCD, Then use SKIP >>| or
SKIP |<< button to change the number where the station will be stored. (NO.1 to NO.15)
3. Store the current frequency by pressing MEMORY/C-ADJ button again when you get the desired
number. (The “P” still appears and will not ash.)
4. Repeat the same procedure to set other desired frequencies into Memory No.1 to NO.15.
Remarks: A stored frequency can only be erased by storing another frequency in its place. The unit
can be preset up to 30 stations. (15 for AM and 15 for FM)
Memory Recall
To recall the stored frequencies, Enter AM or FM band mode rst, press REPEAT/MEM/RCL button
rst then use SKIP >>| or SKIP |<< button to select 1 to 15 station as desired.
Note: As stored frequencies can only be stored for long time with the power supplying, The station you
stored will be lost and can not be recalled in case that you cut off the AC power.
31


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Karcher Audio KA 1015 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Karcher Audio KA 1015 in the language / languages: English, German as an attachment in your email.

The manual is 2,25 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info