Manual Kalorik TKG SIS 9 (page 13 of 44) (English, German, Dutch, French, Italian, Polish, Portuguese, Spanish)

487880

Zoom out

Zoom in

1/44



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced and

folded in order to obtain a booklet A5 (+/- 148.5 mm width x

210 mm height). When folding, make sure you keep the good



the page numbering. Keep the language integrity.

13 TKG SIS 9 - 100226

Assembly page 13/44

Fax +32 2 359 95 50

 Put the steam knob (11) in the desired position according to the fabric to iron (see table

above). Set the temperature dial of the iron (9) to the desired position. When the iron has

reached the desired temperature, its pilot light (1) will go out. You can now use the steam

function.

 As soon as the yellow heating light (14) goes out, press the burst of steam button (8) to

have the steam coming out of the soleplate of the iron. Caution: When you use steam for

the first time, hold the steam button down for about one minute to clean out the steam

producing system. During this operation, you will hear a jerky sound; this is absolutely

normal. Afterwards the steam will come out normally from the soleplate. Every time you

press the steam button, the green pilot light (16) will switch on indicating that steam is

going through the connection cord. When you release the button, the steam will

progressively stop coming out of the soleplate and the green pilot light (16) will go out. If

you want a continuous jet of steam, hold the steam button pressed down.

 When ironing, the pilot light of the iron (1) will go on and off from time to time. This means

that the temperature of the iron is regulated by its thermostat. You can continue ironing.

 When you use a lot of steam in a very short time, the steam output is lightly reduced until

your appliance produces enough steam to make up for the difference. This phenomenon

also happens when there is not enough water in the water tank.

 When the water tank is running empty, you will hear more noise when pressing the steam

button. If you want to go on using the steam function, you will have to refill the water tank.

STEAMING IN A VERTICAL POSITION

You have to hang the garment you want to smooth out avoiding the creases and place the

iron in a vertical position at a few centimetres from the item of clothing. Then move the iron

and press the burst of steam button at the same time.

DRY IRONING



the steam button (8).

WHEN FINISHED IRONING

 Unplug the appliance and let it cool down.

 It is not necessary to empty the water tank.

 We recommend placing the iron on its base when you store it. The foreseen place is non-

slip and will not damage the soleplate of the iron.

ANTI-SCALE CARTRIDGE

 Your appliance is equipped with an anti-scale cartridge (5) located

inside the water tank (4). As a result, you can use tap water as it will

be filtered by the cartridge.

 It is necessary to replace the cartridge approximately every 6 months.

However, this period may vary depending on the frequency of use

and on the scale content of the water in your area. If the water

contains much scale, you will have to replace the cartridge more

frequently.

 To take the cartridge out, remove the water tank as indicated in the



 Then remove the cartridge (5) from the water tank (4) simply by

pulling it out.

 To buy a new cartridge, please contact the nearest customer

service.

 Never use the appliances without anti-scale cartridge!

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Kalorik TKG SIS 9 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 0,58 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Kalorik TKG SIS 9 Manual

Product: