713632

Kalorik TKG KS 1000 Manual

11
Zoom out
Zoom in
Previous page
1/48
Next page
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
11 TKG KS 1000 - 121022
Assembly page 11/48
Fax +32 2 359 95 50
CHARACTERISTICS OF THE ADAPTER
Your appliance is delivered with an adaptor, and if you have to replace it, we advise you to
call in the nearest customer service or, in case of emergency, to pay attention to the following
characteristics:
- Voltage: make sure to respect the voltage of the country you are using the
appliance in.
- Voltage supplied: 5.5V
- Current intensity: 200mA
We accept no liability for damages resulting from non-observance of this paragraph.
FIXING THE WALL-MOUNTING BRACKET (see picture A)
Select a point in the vicinity of a wall socket, indoors and not subject to damp.
The wall-mounting bracket will have to be attached in such a way that the jack plug is
directed upwards.
Put the bracket against the wall considering that the appliance should be placed with the
handle facing upwards. In order to do that, let the cord hang downward.
Take a pencil and mark a dot in each hole situated at the back of the bracket.
Take the bracket off the wall and drill a hole on each dot you just marked.
Put a plug in the holes, hold the holes of the bracket against the plugs and tighten the
screws in the holes of the bracket in order to fix the bracket to the wall. Screw correctly
but do not overtighten in order not to damage the plastic material of the wall bracket.
You can then put the vacuum cleaner (handle facing upwards) on the wall-mounting
bracket.
You can also put the accessories (crevice tool and squeegee) on the sides of the wall-
mounting bracket which are foreseen for this end. The brush accessory can be attached
on top of the crevice tool.
CHARGING THE VACUUM CLEANER
The adaptor should only be connected to a 230V, 50Hz power supply.
Important: The charger and its cord cannot be repaired. Should they be damaged, they must
be thrown out. Contact the customer service to replace them.
Insert the vacuum cleaner on the bracket with its handle facing upwards (a hook at the back
of the appliance allows you to attach it easily to the bracket) (see picture B). Make sure the
"jack" plug enters the appliance in the opening foreseen in the back of the appliance. Insert
the plug of the adapter into a 230V wall socket. The charging indicator will come on,
indicating that the vacuum cleaner is positioned correctly on the bracket and that the
charging process will start. The charging indicator will stay illuminated even if the battery is fully
charged.
You can leave your appliance on the bracket for a long time without any risk of deterioration.
Do not charge the battery if the room temperature falls below 0°C or rises to more than 37°C.
The charger will warm up during use. This is perfectly normal. It will cool down as soon as the
charging process is over.
USE
Once your appliance is charged, remove it from the bracket by holding it by its handle. Switch
it on by sliding the ON/OFF switch forward. Tilt the vacuum cleaner till the nozzle of the dust
collector is placed horizontally compared to the surface that is to be cleaned. When you are
finished, slide the ON/OFF switch backward to switch off the appliance.
To clean surfaces that are difficult to reach, use the crevice tool supplied.
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kalorik TKG KS 1000 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kalorik TKG KS 1000 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 1,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info