487686

Kalorik TKG FT 18 Manual

10
Zoom out
Zoom in
Previous page
1/52
Next page
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International BELGIUM.
The pages must be reproduced and folded in order to obtain a
booklet A5 (+/- 148.5 mm width x 210 mm height). When folding,
make sure you keep the good numbering when you turn the pages
Keep the language
integrity.
10 TKG FT 18 - 090325
Assembly page 10/52
Fax +32 2 359 95 50
Provide proper ventilation when using the appliance.
If you wish to use solid fat, cut it into small pieces and place into the bowl. Turn the
temperature knob to its minimum position. Each time the pilot light goes out, turn the
temperature knob to a slightly higher temperature until all the fat has melted. Once all the
fat has melted, set the temperature knob to the desired cooking temperature. This type of
fat will solidify when the appliance cools down.
Your appliance must never be switched on through an external timer or any kind of
separate remote control system.
(*)
Competent qualified electrician: after sales department of the producer or importer or any
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this electrician.
BEFORE USE
When the fryer is new, the force of the lid spring is quite strong. After the fryer has been
used 10-15 times the spring force will reduce. This is quite normal.
Remove all packaging from the unit.
Before you use the deep fat fryer for the first time, we recommend that you clean the lid,
bowl, basket, handle and jacket of the deep fat fryer with warm soapy water with a soft
cloth. This will remove any residue left from the manufacture of this unit. See "Cleaning"
section.
DISASSEMBLING THE DEEP FAT FRYER
Stand the appliance on a dry horizontal surface.
Open the lid by pressing its opening button, push it gently backwards until it is in vertical
position and detach it by pulling it upwards.
Raise the handle and remove the basket.
A mechanism will block the handle in its horizontal position and you will have to press the
handle release button to come back to the starting position.
ASSEMBLING THE DEEP FAT FRYER
Stand the appliance on a dry horizontal surface.
Place the handle into the slot on the front of the fryer. Pull the handle release button
towards you and swing the handle down. This will allow you to lower the basket
completely into the bowl. To raise the basket, proceed inversely.
Hold the lid vertically and put the spring in the slot in the rear part of the fryer. Close the lid.
FIRST USE
When using the appliance for the first time, pour the required amount of oil in the bowl,
making sure that the level is between the MIN and MAX marks indicated inside the bowl.
We recommend that you use exclusively liquid oil that is suitable for deep fat frying. Check
the label on the bottle. If you wish to use a solid fat, cut the fat in small pieces. Plug in the
appliance, put the thermostat on the lowest position and add the fat pieces slowly. When
the fat has melted, set the thermostat to the desired temperature. WARNING: FAILURE TO
OBSERVE THIS WILL DAMAGE YOUR DEEP FAT FRYER.
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kalorik TKG FT 18 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kalorik TKG FT 18 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 0,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info