491538

Kalorik KA EL 2-7 Manual

8
Zoom out
Zoom in
Previous page
1/20
Next page
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International BELGIUM.
The page must reproduced and folded in order to obtain a mini
booklet A5 (+/- 150 mm width x 210 mm height). The page must be
folded in order to keep the good numbering when you turn the page
of the I/B . Don’t change the page numbering. Keep the language
integrity.
8
Assembly page 8/20
Fax +32 2 359 95 50
UK STYLE PLUG WIRING INSTRUCTIONS (IN THE UK ONLY)
This product must only be used from a 13-amp power socket. If a BS1363 approved 13-amp
plug is used, it should be fitted with a 13-amp fuse. The wires on the power cord are colour
coded:
blue = neutral, brown = live, green or green & yellow = earth.
The blue wire must be connected to the terminal marked N or coloured in black.
The brown wire must be connected to the terminal marked L or coloured in red.
The green (& yellow) wire must be connected to the terminal marked E or coloured in green (&
yellow).
CONNECTION TO THE MAINS SUPPLY
The radiator should only be connected to an earthed socket installed in accordance with the
regulations.
Make sure that the supply voltage corresponds with the voltage marked on the rating label
(230V (AC)) and the rated electric current is not lower than 10A.
This product complies with all binding CE- labelling directives.
START UP
Before using the radiator for the first time, make sure the wheels are fitted correctly to the base
of the appliance (see page 2, a and b). Never use the appliance if the wheels are not fitted
correctly.
When the appliance is switched on for the first time, a slight smell may be emitted. Please
ensure sufficient ventilation.
USE
Turn the thermostat clockwise to high position and switch the unit by pressing the power
switches I for low heat, the switch II for high heat.
When your room reaches the desired temperature, slowly turn the thermostat counter-
clockwise until the pilot light goes out. The thermostat can now be left at this setting. As
soon as the room temperature has dropped below the set temperature, the unit will switch
itself on automatically until the set temperature has been reached again. In this way, the
room temperature remains constant. The pilot light indicates whether or not the appliance
is heating.
If you want to change the room temperature setting, turn the thermostat clockwise to
raise temperature, or counter-clockwise to lower it.
To switch off the appliance, put the power buttons in OFF position and unplug the
appliance.
OVERHEAT PROTECTION
This heater is protected with an overheat protection that switches off the appliance
automatically in case of overheat. In this case, unplug the appliance, wait about 10 minutes
for it to cool. Then switch it back on as described above. The appliance should operate
normally. Should the problem persist, please contact the nearest customer service.
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kalorik KA EL 2-7 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kalorik KA EL 2-7 in the language / languages: English, German, Dutch, French, Portuguese, Spanish as an attachment in your email.

The manual is 0,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info