491357

Kalorik KA CV 14 T Manual

5
Zoom out
Zoom in
Previous page
1/12
Next page
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
5 KA CV 14 T - 070510
Assembly page 5/12
Fax +32 2 359 95 50
CONNECTION TO THE MAINS SUPPLY
Caution: We cannot be held responsible for any damage due to the wrong use or the non-
observance of this instruction manual.
The convection heater should only be connected to an earthed socket installed in
accordance with the regulations. Make sure that the supply voltage corresponds with the
voltage marked on the rating label.
This product complies with CE-directives.
BEFORE THE FIRST USE
Before using the convection heater for the first time, you must either attach the feet to the
base of the unit or mount the appliance on the wall.
Floor-standing (see page 3)
Attach each foot underneath the appliance by tightening two screws provided in the holes
foreseen to this effect as indicated on page 3. Make sure to install the appliance at a minimum
distance of 50 cm to other objects or walls.
Wall-mounting (see pictures page 3)
Caution: - there should be a distance of at least 40 cm between the lower part of the
appliance and the floor.
- the feet must be removed before mounting the appliance on the wall
1. Measure the distance between the two slots situated at the back of the appliance (see
picture A)
2. Drill two holes at the same distance in the wall and insert a plug in each hole you just
drilled. Place the brackets facing the holes as indicated on picture B and attach them in
this position with the screws supplied.
3. Before attaching the appliance on the brackets, attach the two other brackets
underneath the appliance as indicated on picture C.
4. Attach the appliance on the wall. To do so, hold it in such way that the slots are facing the
brackets, insert the appliance halfway onto the brackets until the appliance can go down
into the grooves of the brackets.
5. As soon as the appliance is positioned correctly, take a pencil and mark a dot in the hole
of each bracket situated underneath the appliance.
6. Then take off the appliance by proceeding the other way around compared to point 4
above.
7. Drill a hole in the wall on each dot you just marked and insert a plug in each hole.
8. Attach the appliance back on the wall as indicated in point 4, insert screws through the
brackets underneath the appliance and tighten without forcing.
OPERATION
When the appliance is switched on for the first time, a slight smell may be emitted. Please
ensure sufficient ventilation. This smell will disappear very quickly.
With the power switches you can regulate the heating intensity. The thermostat allows you to
keep a constant room temperature.
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kalorik KA CV 14 T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kalorik KA CV 14 T in the language / languages: English, Spanish as an attachment in your email.

The manual is 0,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info