491060

Kalorik KA CH 9 Manual

8
Zoom out
Zoom in
Previous page
1/16
Next page
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced and
folded in order to obtain a booklet A5 (+/- 148.5 mm width x
210 mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don‟t change
the page numbering. Keep the language integrity.
8 KA CH 9 - 070523
Assembly page 8/16
Fax +32 2 359 95 50
NOTE: If you switch off the fireplace heater with the ON/OFF switch, the set heat mode will be
saved for next use, i.e. the next time you will switch on your heater, it will start heating directly
at the previously set heat mode. If you unplug the appliance, all previous settings will be
deleted.
Timer function
By pressing the "TIMER" button on the control panel or of the remote control, you can set the
switch-off time of the appliance. The timer is adjustable from 0.5 hour (min) up to 7.5 hours
(max). Every pressing corresponds to 0.5 hour. Some settings will switch on several pilot lights.
For instance, if you select 1 hour and 30 minutes, the pilot lights corresponding to 0.5h and 1h
will be on.
CLEANING AND MAINTENANCE
Warning: The unit must be unplugged from the power supply prior to any maintenance or
cleaning in order to reduce the risk electric shock or fire.
A. Light bulb replacement procedure
Like all light bulbs, bulbs require periodic replacement. When the bulbs in your unit have
burned out you will notice one or more of the following:
The flame is dim or dark in certain areas
The log set ember bed appears dim or dark in certain areas
Your unit must be opened in order to replace the light bulbs. To reduce the number of times
you need to open the unit, replace all the lights bulbs at the same time if they are close to the
end of their rated life.
Warnings:
The light bulbs in your unit can become extremely hot. Allow at least 10 minutes between
turning off the unit and removing the light bulbs to avoid the accidental burning of the
skin.
Always make sure to replace the bulbs by a bulb with exactly the same features.
Replacing bulbs (see figures page 4-5)
Below the log ember bed there are two light bulbs. To replace them, proceed as follows:
Lay down the appliance very carefully.
Unscrew the two screws situated at the left and right end of the metallic plate of the
control panel (fig. 1).
Remove the metal fixing bar from the window (fig. 2). Then slowly tilt the glass outwards
and pull it out of the lower slot (fig. 3).
When the glass is removed, remove the log ember bed by taking its lugs out of the slots
and lifting it (fig. 4).
You now have access to the bulbs (fig. 5). Unscrew them and replace them by identical
bulbs.
Once this is done, reassemble the appliance by proceeding the other way around. Make
sure the plastic gaskets are correctly positioned on both sides of the glass (fig. 6).
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kalorik KA CH 9 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kalorik KA CH 9 in the language / languages: English, Portuguese as an attachment in your email.

The manual is 0,45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info