Manual Kalorik KA CH 2 (page 7 of 20) (English, Portuguese, Spanish)

491055

Zoom out

Zoom in

1/20



Copies of the I/B. Please reproduce them without any

changes except under special instruction from Team

International BELGIUM. The pages must be reproduced and

folded in order to obtain a booklet A5 (+/- 148.5 mm width x

210 mm height). When folding, make sure you keep the good

numbering when you turn the pages of the I/B. Don’t change

the page numbering. Keep the language integrity.

7 KA CH 2 - 060519

Assembly page 7/20

Fax +32 2 359 95 50

INSTALLATION

The heater should only be installed at a minimum distance of 1 meter from any piece of

furniture or other object and combustibles.

This fireplace heater can also be installed in a standard fireplace hole, but make sure to keep

at least 20 cm of free space around the appliance (rear and sides).

Once you have installed the main unit where you desired, attach the front panel. To do so,

insert the pins of the panel in the bolts foreseen to this effect on the appliance (fig. 1, page 4)

REMOTE CONTROL

 In order to be able to use the remote control, you first have to insert the batteries in it. To

do so:

 Open the battery compartment by pressing on the cover and sliding this cover down.

 Insert the batteries, making sure you respect the + and – polarity.

 Close the compartment by sliding the cover in the opposite direction. Use 2 AAA-type

batteries of 1.5 V. Never mix up new and old batteries or batteries of different types.

 When you decide to throw away the appliance, make sure to remove the battery and to

dispose of it in an ecological manner by handing it in a place intended for this end.

Caution: if you don’t use your remote control for a long time, it is recommended to remove the

batteries because they could run.

OPERATION

 Always put the plug in an earthed power outlet.

 You can operate the appliance by means of the control panel on the appliance or with

the remote control. The controls panel is located in the upper part of the frame of the

fireplace, behind the protection grid. To reach it, simply pull at the upper part of the grid

to open it (fig.2, page 4).

 Once plugged in, switch on the appliance by pressing the on/off button of the control

panel or remote control. A beep will sound and the power indication light comes on. The

appliance will start operating without heating. To adjust the flame effect, press the "up"

button to increase the intensity and the "down" button to decrease the intensity. A beep

will sound and the corresponding pilot light will flash.

Heating function:

Note: When first used, the heater may release a slight, harmless odour. This odour is a normal

occurrence caused by the initial heating of the internal heating elements and will not occur

again.

 If you want to switch on the heating function, press the "heater" button of the control

panel or remote control.

 The fan will start to operate 5 seconds at first, then the heater will start operating in low

grade and the "L" pilot light flashes.

 To increase the heating intensity, press the "heater" button again to rise up to high grade.

The "H" pilot light flashes. To come back to low temperature, press the heater button

again.

 An internal safety device will test the fan. If the fan is out of control, the heater will stop

operating. The "H" and "L" pilot lights will flash simultaneously to warn about a problem with

the heater. The flame effect will still operate. In case of heating problem, please check if

the air inlet and outlet grids are not obstructed, switch off and unplug the appliance. Then

plug in and switch on again. The "H" and "L" pilot lights will stop flashing after the problem

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Kalorik KA CH 2 in the language / languages: English, Portuguese, Spanish as an attachment in your email.

The manual is 0,45 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Kalorik KA CH 2 Manual

Product: