491020
12
Zoom out
Zoom in
Previous page
1/28
Next page
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
12 KA BBM 2 - 070524
Assembly page 12/28
Fax +32 2 359 95 50
Switch off the battery operated appliances before changing the batteries or when
cleaning accessories.
When replacing the batteries, do not throw the old one in the regular dustbin, but
eliminate it in an environment-friendly way by throwing it in a container especially
intended for that purpose.
(*)
Competent qualified electrician: after sales department of the producer or importer or any
person who is qualified, approved and competent to perform this kind of repairs in order to
avoid all danger. In any case you should return the appliance to this electrician.
BUBBLE MAT
INSTALLATION OF THE BUBBLE MAT'S MOTOR UNIT
The main unit is designed for wall-mounting to ensure complete electrical safety (NB: if you
have any doubt at all about correct positioning or fixing, always consult a qualified
electrician).
However, this appliance may also be used if it is not mounted on the wall, as long as certain
safety distances are observed, see below.
Wall-mounting:
We recommend wall fixing not less than 1 meter horizontally from the bath at a height of
1.8 meters from the floor. The main unit must be positioned where it cannot be touched by
anyone in the bath.
Under no circumstances should it be fixed where it could fall into the bath, sink or toilet.
The main unit should be hung with the air outlet at the bottom.
Measure the distance between the holes situated at the back of the bracket and drill two
holes in the wall at the same distance, taking extreme care not to drill through electric
cables, water or gas pipes that may be located in the wall.
Fully push the wall anchoring plugs into the holes and screw in the 2 screws by letting them
more or less 7 millimetres out of the wall. (note: for hollow studded walls, special anchors
will be required for secure fixing these are not provided).
Position the main unit so that the screw heads enter the circular hole in the keyhole-
shaped holes on the back.
Pull the main unit downward to secure it onto the fixing screws. Note: the depth of the
screws may need adjusting to ensure a tight, secure fit.
Installation without wall mounting:
Always make sure that the appliance is installed at a distance of at least 1 meter from the
bathtub.
Under no circumstances should it be installed where it could fall into the bath, sink or toilet.
Make sure the motor housing is out of reach of the user who is in the bathtub.
BUBBLE MAT OPERATING INSTRUCTIONS
Put the mat into the empty bathtub and press to secure the suction cups onto the bathtub
floor. If the suction cups do not stick well to the bottom, slightly moisten them first.
Insert the valve end of the hose (end with small arrows) into the motor unit and twist
clockwise to lock.
Insert the other end of the hose tube into the mat connector.
Fill the bathtub with water until the desired level is reached.
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kalorik KA BBM 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kalorik KA BBM 2 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 0,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info