694582
33
Zoom out
Zoom in
Previous page
1/55
Next page
6.2 Opening the lifting door
1. Insert the key supplied with the fireplace, with the short
side in the small hole of the door on the bottom right.
2. Move the key up. The first 3 cm can be quite dicult,
because the door has to be pulled out of the lock. After this,
it will be easier.
3. The door can be left open in any desired position.
4. To close the door, place the key in the small hole of the door
at the top right and move the key down.
Figure 31: Illustration of the end of the key (detail)
Figure 32: Operating key
6 Lighting the fireplace
6.1 Lighting the fireplace for the first time
CAREFUL! When the fireplace is lit for the first time, the
enamel will burn in and cure. This causes nuisance in the
form of odour and fumes. If the fireplace has a slatted rear
panel, use only a very small quantity of wood (max. 2 kg/
hour) the first time a fire is lit. If too much wood is burned,
the paint could burn or flake o of the slatted rear panel.
Make sure the room in which the fireplace is located is well
ventilated. It is advisable to light the fireplace during the
day, and open all doors and windows in order to reduce the
odour nuisance. Proper ventilation also reduces the risk of
discolouration. Below are some tips from the Dutch decorative
heating guild (see www.sfeerverwarmingsgilde.nl/faq):
Minimise the use of candles and oil lamps and keep the
wick as short as possible. Candles and oil lamps produce
considerable amounts of soiling and unhealthy soot
particles in your home.
Wait at least 6 weeks before igniting a newly installed
masonry mantelpiece or after renovation work. The building
moisture must disappear completely from the walls, floor
and ceiling.
With renovations or new building work, ensure there is
extra ventilation to remove volatile solutions from your
home.
Avoid smoking. Smoking is not only bad for your health, but
cigarette and cigar smoke also contain tar that will cause
deposits on colder and damp walls when heated.
WARNING Enamel that has not yet cured is particularly
sensitive. Avoid touching the enamelled parts of the
fireplace. Leave the door open, approximately 5 cm, the first
time that the fireplace is lit and close the door after it has
cooled down. When heated the enamel is soft and will stick
sooner. If the door does stick to the fireplace, it can be tilted
(see Section 7.5)
Air regulation operation
Door operation
33
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kalfire W71-620F at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kalfire W71-620F in the language / languages: English as an attachment in your email.

The manual is 8,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kalfire W71-620F

Kalfire W71-620F User Manual - German - 56 pages

Kalfire W71-620F User Manual - Dutch - 55 pages

Kalfire W71-620F User Manual - French - 55 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info