694582
29
Zoom out
Zoom in
Previous page
1/55
Next page
Figure 28: W53/50R, W65/38C, W90/47C, W66/48S, W90/47S
Bae plates
Bae plates
Figure 29: W80/52T and W105/47T
Kalfire W53/50R, W65/38C, W90/47C, W66/48S and W90/47S
1. Remove the bae plate and see if this solves the problem.
If the problem still occurs, remove the upper bae plate. If
the problem still occurs, then something else is the cause.
If removing the plate solves the problem, proceed with the
next step.
2. Use a saw to cut away a 3-cm wide strip at the front and the
rear of the bae plate. If necessary, do this for both bae
plates.
A 3-sided and a corner fireplace is always a more sensitive
product than a fireplace with a door at the front. Particularly
when used with an open door. When the Kalfire W53/50R,
W65/38C, W90/47S, W66/48C of W90/47S S is used as an open
fireplace, some smoke may flow back into the room. Even if both
bae plates have been removed. This may have a number of
causes:
- Insucient pull in the chimney duct.
- The air flow patterns in the room where the 3-sided
fireplace has been installed.
- Too low ignition temperature.
CAREFUL! The Kalfire W53/50R is not suitable to be used
as an open fireplace. Only open the door of the firebox if
strictly necessary (e.g. to add logs)
Kalfire W80/52T and W105/47T
1. First remove all bae plates (6 pieces). If this solves the
problem, it is a good idea to adjust the bae plates. Proceed
with step 2 and/or 3. If the situation remains unchanged,
the appliance is not the cause of the problem, so there is
no point in adjusting the bae plates, replace them in the
fireplace.
2. To begin, cut a strip approximately 1 cm wide at the front
of the bae plate using a saw, and check whether this
provides sucient results. If the result is insucient, you can
once again cut o a strip and repeat this until the desired
result is achieved.
CAREFUL! Take care that the plates are still able to rest on
the supports.
3. In certain situations, it may be necessary to remove the
bae plate entirely.
CAREFUL! The Kalfire W80/52T and W105/47T are not
suitable to be used as an open fireplace. Only open the door
of the firebox if strictly necessary (e.g. to add logs).
29
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kalfire W71-620F at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kalfire W71-620F in the language / languages: English as an attachment in your email.

The manual is 8,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kalfire W71-620F

Kalfire W71-620F User Manual - German - 56 pages

Kalfire W71-620F User Manual - Dutch - 55 pages

Kalfire W71-620F User Manual - French - 55 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info