Manual Jydepejsen Troja (page 49 of 146) (English, German, Dutch, Danish, French, Italian, Swedish, Norwegian)

707616

Zoom out

Zoom in

1/146

7. Stoking Instructions

It is very important to ensure that your chimney has a decent draught (at least 12 Pa chimney draught). The

Alpha and Omega is the cooperation between the chimney and the stove. The draft is affected both by the

length and the area of the chimney, as well as by how well the chimney is sealed. The minimum recommended

chimney length is 3.5 m, and the suitable cross-section area is 150-200 sq. cm (140-160 mm in diameter).

Your dealer or your chimney sweep will be able to guide and advise you on your chimney conditions.

If the

chimney has not been used for a while, it has to be inspected for blockages. In some cases, it can be relevant

to install a draught control device in order to be able to control the draught in the stove.

Fuel

The product has been tested and approved pursuant to EN13240 and NS 3058 for stoking with split, dried birch wood

with a water content of 12-20%. Stoking with wet firewood results in soot, environmental pollution and bad fuel

economy.

Newly cut wood contains approx. 60-70 % water and is absolutely unsuitable for stoking. At least 1 year

of storage time is necessary for newly cut wood before it can be used. Regardless of the wood size, it should

always be split and have at least one bark-free side.

We strongly advise against stoking with impregnated, painted and laminated wood,

plywood, chipboard, domestic waste, milk cartons, printed paper or the like. The use of

these materials invalidates the warranty since they can produce poisonous corrosive

or hazardous fumes.

Furthermore, the poisonous gas dioxin can be produced, which is damaging both to

the stove and to the environment.

USE RECOMMENDED FUELS ONLY

Recommended Fuels

The following table shows the calorific value of the different types of wood, which have been stored for 2 years

and have residual moisture of 15-17%.

Wood Kg dry wood per m3

compared to

beech/oak

Hornbeam 640

110%

Beech and oak

580

100%

Ash

570

98%

Maple

540

93%

Birch

510

88%

Mountain pine

480

83%

Fir

390

67%

Poplar

380

65%

1 kg of wood yields the same heat energy irrespective of wood type. 1 kg beech merely takes up less space than 1

kg of fir.

When this is settled, the next important step is to ensure that the chimney and the stove work well together.

This is done by following the operating instructions carefully and using dry fuel that inflames easily. For further

information on correct kindling and stoking, please refer to Jydepejsen's Manual for installation and stoking.

Please note that the stove paint will harden during the initial stoking. Touching the stove should be avoided since

this may cause the paint to scale. Ensure effective ventilation during this phase because the stove can generate

smoke and unpleasant odour. The smoke and the odour are not harmful and will dissipate after about 1 hour of

operation.

The stove will expand and contract during the stoking and cooling phase, which could result in creaking noises.

This phenomenon is completely normal for sheet-iron stoves and cannot be regarded as a fault. All Jydepejsen

wood-burning stoves are intermittent, which means that new wood should be added when there is a layer of

embers in the burning chamber.

Incorrect stoking or combustion is often due to wet wood or insufficient draft in the chimney.

Always

make sure that the chimney is not blocked and that the vermiculite panels are properly placed.

case of overheating or chimney fire, shut off all air supply and monitor the situation.

Never attempt to put off a chimney fire with water because steam will form (water evaporates at a rate of 1:1700),

resulting in a fast pressure build-up, which can cause serious damage to the chimney.

UK - 7

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Jydepejsen Troja in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Norwegian as an attachment in your email.

The manual is 4,06 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Jydepejsen Troja Manual

Product: