29869
27
Zoom out
Zoom in
Previous page
1/32
Next page
24
Maintenance
Troubleshooting
If you are having a problem with your unit, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person,
such as your dealer, for service.
Symptom
No sound is heard.
Hard to listen to broadcasts because of
noise.
The disc tray does not open or close.
The disc does not play.
The disc sound is discontinuous.
The cassette holder cannot be opened.
Impossible to record.
Operations are disabled.
Unable to operate the unit from the
remote control.
Cause
Connections are incorrect or loose.
Headphones are connected.
Antennas are disconnected.
The AM loop antenna is too close to
the unit.
The FM antenna is not properly
extended and positioned.
The AC power cord is not plugged in.
The disc is placed upside down.
The disc is scratched or dirty.
Power from the AC power cord has
been cut off while the tape was running.
Small tabs on the back of the cassette
are removed.
The built-in microprocessor may
malfunction due to external electrical
interference.
The path between the remote control
and the remote sensor on the unit is
blocked.
The batteries are exhausted.
Action
Check all connections and make
corrections. (See pages 6 8.)
Disconnect the headphones.
Reconnect the antennas correctly and
securely.
Change the position and direction of
the AM loop antenna.
Extend the FM antenna to the best
position.
Plug the AC power cord.
Place the disc with the label side up.
Clean or replace the disc. (See page
16.)
Plug in the AC power cord, then turn on
the unit.
Cover the holes with adhesive tape.
Unplug the AC power cord and then
plug it back in.
Remove the obstruction.
Replace the batteries.
Handling cassette tapes
If the tape is loose in its cassette, take up the
slack by inserting a pencil in one of the reels
and rotating.
If the tape is loose, it may get stretched, cut,
or caught in the cassette.
Be careful not to touch the tape surface.
Avoid storing tapes in the following places:
In dusty places
In direct sunlight or heat
In moist areas
On a TV or speaker
Near a magnet
Cleaning the unit
Stains on the unit
Should be wiped off with a soft cloth. If the unit is heavily
stained, wipe it with a cloth soaked in water-diluted neutral
detergent and wrung well, then wipe clean with a dry cloth.
Since the unit may deteriorate in quality, become
damaged or have its paint peel, be careful about the
following.
DO NOT wipe it with a rough cloth.
DO NOT wipe it strongly.
DO NOT wipe it with thinner or benzine.
DO NOT apply any volatile substances such as
insecticides to it.
DO NOT allow any rubber or plastic to remain in contact
with it for a long time.
To get the best performance from the unit, keep your discs, tapes, and mechanism clean.
EN20-26_UX-J60&50[B]f.pm6 02.12.23, 9:35 AM24
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC UXJ50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC UXJ50 in the language / languages: English as an attachment in your email.

The manual is 1,02 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info