29936
25
Zoom out
Zoom in
Previous page
1/26
Next page
22
If you are having a problem with your unit, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person,
such as your dealer, for service.
Troubleshooting
Symptom
Power does not come on.
No sound is heard.
Hard to listen to broadcasts because of
noise.
The disc does not play.
Impossible to record.
Operations are disabled.
Unable to operate the unit by the remote
control.
Possible Cause
The power cord is not connected to an
AC outlet.
Connections are incorrect or loose.
A pair of headphones is connected.
Antennas are disconnected.
The AM (MW) loop antenna is too
close to the unit.
The FM antenna is not properly
extended and positioned.
The disc is upside down.
Small tabs on the back of the cassette are
removed.
The built-in microprocessor has
malfunctioned due to external electrical
interference.
The path between the remote control
and the remote sensor on the unit is
blocked.
The batteries are exhausted.
You are using the remote control too
far from the unit.
Action
Insert the plug into the socket.
Check all connections and make
corrections. (See pages 6 and 7.)
Unplug the headphones from the
PHONES jack.
Reconnect the antenna correctly and
securely.
Change the position and direction of
the AM (MW) loop antenna.
Extend FM antenna and orient to the
best reception position.
Put the disc in with the label side up.
Cover the holes with adhesive tape.
Unplug the AC power cord then plug it
back in.
Remove the obstruction.
Replace the batteries. (See page 6.)
Signals cannot reach the remote
sensor. Move closer to the unit.
Amplifier SectionCA-UXH10
Output Power (IEC 268-3):
10 W (5 W + 5 W) at 4 (10% THD)
Speakers/Impedance: 4 16
Tuner
FM tuning range: 87.50 MHz108.00 MHz
AM (MW) tuning range: 522 kHz1 629 kHz
CD player
Dynamic range: 60 dB
Signal-to-noise ratio: 60 dB
Wow and flutter: Immeasurable
Cassette deck
Frequency response:
Normal (type I): 100 Hz10 000 Hz
Wow and flutter: 0.35 % (WRMS)
Specifications
General
Power requirement: AC 230 V , 50 Hz
Power consumption: 22 W (at operation)
3.0 W (on standby)
Dimensions (W/H/D) (approx.):
145 mm x 209 mm x 226 mm
Mass (approx.): 2.8 kg
Supplied accessories
See page 6.
Speaker SectionSP-UXH10
Type: Full range Bass-reflex type
Speakers: 10 cm cone x1
Power handling capacity: 5 W
Impedance: 4
Frequency range: 100 Hz to 15 kHz
Dimensions (W/H/D) (approx.):
135 mm x 209 mm x 152 mm
Mass (approx.): 1.3 kg each
Design and specifications are subject to change without notice.
UX-H10[B]_ext.p65 03.5.15, 4:30 PM22
25


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC UXH10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC UXH10 in the language / languages: English as an attachment in your email.

The manual is 0,71 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info