614784

JVC UX-T550 Manual

19
Zoom out
Zoom in
Previous page
1/20
Next page
16
SLEEP
● Sleep time settings of 30, 60, 90 or 120 minutes can be set. When you
release the SLEEP button, the source is displayed after 5 sec.
● The sleep timer operation will start and the power will be switched off
after the specified time.
● Checking the sleep time
When the SLEEP button is pressed, the remaining sleep time is dis-
played. If it is pressed again, a new sleep time can be set.
● To cancel the sleep timer operation
Press the button to switch the power off or press the SLEEP
button until the sleep time indicator disappears.
● Any source can be selected for sleep timer operation and timer play-
back. For example;
• CD play for sleep timer operation and broadcast reception for timer
playback.
• Tape playback for sleep timer operation and CD play for timer play-
back.
However, when broadcast reception is selected for both sleep timer
operation and timer playback, the station you heard at night will be tuned
to the following morning.
Source mode display (Releasing the sleep mode)
SLEEP is shown in the display.
SLEEP
Source mode display (Releasing the sleep mode)
Sleep timer operations (using the remote control unit)
A. Use this when you want to fall asleep while listening to a tape,
broadcast or CD.
1 Set to the required source and tune (broadcast) or play back (CD or
tape).
2 Press the SLEEP button to set the sleep time.
B. To fall asleep while listening to a tape, broadcast or CD and to
perform timer playback the following morning
1 Set the timer. (Refer to “Setting the timer” on page 14.)
2 Set to the required source (broadcast, tape or CD).
3 Press the SLEEP button to set the sleep time.
TROUBLESHOOTING
What appears to be trouble is not always serious. First make sure....
● Power cannot be turned on.
* Is the power cord unplugged?
● No sound from the speakers.
* Are headphones connected?
CD Player Section
● The CD player does not play.
* Is the CD upside down?
* Is the CD dirty?
● A certain portion of the CD does not play correctly.
* Is the CD scratched?
Cassette Deck Section
● Playback sound is at a very low level.
* Is the head dirty?
● The ONE TOUCH REC button does not function.
* Have the safety tabs of the cassette been broken off?
Tuner Section
● Reception is noisy.
* Try adjusting the antenna.
Timer Section
● Timer operation does not start.
* Is the current time set correctly?
* Is the timer mode ( ) displayed?
Remote Control
● Remote control is impossible.
* Are the batteries in the remote control exhausted?
* Is the remote sensor section exposed to bright light (direct sunlight,
etc.)?
Note:
Before making an important recording, be sure to make a test record-
ing first to check that the deck, etc. is working correctly.
● When the above remedies do not help
Many operations of this unit are performed by the control of a
microprocessor. If none of the buttons function, unplug the power
cord, wait for a while, then plug it back in. Reset the correct val-
ues for the clock and timer.
Cleaning is important!
When the tape is running, magnetic powder and dust naturally accu-
mulate on the heads, capstan and pinch roller. When they become too
dirty...
● Sound quality deteriorates.
● The output sound level drops.
● Previously recorded tape is not completely erased.
● Recording is not performed satisfactorily.
Therefore, you should clean the heads, etc. after every 10 hours of use
for optimal recording conditions.
Cleaning the heads, capstan and pinch roller
Open the cassette holder.
Clean the heads, pinch roller and capstan.
For effective cleaning, use a cleaning kit available from an audio store.
After cleaning, be sure that the cleaning fluid has dried completely be-
fore loading a cassette.
MAINTENANCE
Cautions:
1. Keep magnets and metallic objects away from the
head.
If the head becomes magnetized, noise will increase and the sound
will deteriorate. Demagnetize the head every 20–30 hours of use
with a head eraser (available from an audio store). (When demag-
netizing the head, the button should be set to STANDBY.)
2. Do not use anything other than alcohol for cleaning.
Thinner and benzine will damage the rubber pinch roller.
Cleaning the lens
If the lens in the CD pickup is dirty, dropout, etc., could degrade sound.
Open the CD holder and clean the lens as shown.
● Use a blower (available from a camera store) to blow dust off the lens.
● If there are fingerprints, etc. on the lens, gently wipe clean with a
cotton swab.
Capstan shaft(s)
Pinch roller(s)
Combination record/play head
Erase head
Lens
Blower
UX-T550(B)_body.pm6 12/12/00, 3:11 PM16
… 19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC UX-T550 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC UX-T550 in the language / languages: English as an attachment in your email.

The manual is 0,68 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info