495432
10
Zoom out
Zoom in
Previous page
1/75
Next page
5
Getting started
Putting batteries in the remote control
Before using the remote control, put two supplied batteries first.
1
Press and slide the
buttery cover on the bac k
of the remote control.
2
Inser t batteries.
Make sure to match the polarity:
(+) to (+) and () to ().
3
Replace the co ver.
If the range or effectiveness of the remote control decreases, replace
the batteries. Use two R6P(SUM-3)/AA(15F) type dry-cell batteries.
Supplied butteries are for initial setup. Replace for continued use.
CAUTION:
Follow these precautions to avoid leaking or cracking cells:
Place batteries in the remote control so they match the polarity:
(+) to (+) and () to ().
Use the correct type of batteries. Batteries that look similar may
differ in voltage.
Always replace both batteries at the same time.
Do not expose batteries to heat or flame.
When using the remote control, aim the remote control directly at the
remote sensor on the front panel.
Precautions
General precautions
DO NOT disassemble the unit or remove screws, covers, or
cabinet.
DO NOT expose the unit to rain or moisture.
DO NOT expose the unit to direct sunlight or place it near a heating
device.
Locations
Install the receiver in a location that is level and protected from
moisture and dust.
If water gets inside the unit, turn off the power and remove the plug
from the outlet, then consult your dealer. Using the unit in this state
may cause a fire or electrical shock.
Select a place which is level, dry and neither too hot nor too cold
between 5˚C and 35˚C
Make sure there is good ventilation around the receiver. Poor
ventilation could cause overheating and damage the receiver.
Leave sufficient distance between the unit and the TV.
Do not install the unit in a place subject to vibrations.
Handling the receiver
DO NOT touch the power cord with wet hands.
DO NOT pull on the power cord to unplug the cord. When
unplugging the cord, always grasp the plug so as not to damage the
cord.
Keep the power cord away from the connecting cords and the
antenna. The power cord may cause noise or screen interference. It
is recommended to use a coaxial cable for antenna connection,
since it is well-shielded against interference.
When a power failure occurs, or when you unplug the power cord,
the preset settings such as preset FM or AM (MW) channels and
sound adjustments may be erased in a few days.
When you are away on travel or otherwise for an extended period
or time, remove the plug from the wall outlet. A small amount of
power is always consumed while the power cord is connected to the
wall outlet.
To prevent the malfunction
There are no user-servicable parts inside. If anything goes wrong,
unplug the power cord and consult your dealer.
Do not insert any metallic objects, such as wires, hairpins, coins,
etc, into the unit.
Do not block the vents. Blocking the vents may damage the unit.
To clean the cabinet
Use a soft cloth. Follow the relevant instructions on the use of
chemically-coated cloths.
Do not use benzene, thinner or other organic solvents and
disinfectants. These may cause deformation or discoloring.
Checking the supplied accessories
Check to be sure you have all of the following supplied accessories.
The number in parentheses indicates the quantity of each piece
supplied.
Remote control (1)
Batteries (2)
AM (MW) loop antenna (1)
FM antenna (1)
SCART cable (1)
Digital coaxial cord (1)
If anything is missing, contact your dealer immediately.
Remote sensor
Remote sensor
XV-N55SL
RX-ES1SL
01-10.RX-ES1&XV-N55[B]f 03.2.18, 1:47 PM5
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC RX-ES1SL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC RX-ES1SL in the language / languages: English as an attachment in your email.

The manual is 3,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info