469766
6
Zoom out
Zoom in
Previous page
1/50
Next page
3
Getting Started
Putting Batteries in the Remote Control
Before using the remote control, put two supplied batteries first.
When using the remote control, aim the remote control directly at
the remote sensor on the unit.
1. On the back of the remote control, remove the
battery cover.
2. Insert batteries. Make sure to match the polarity:
(+) to (+) and (–) to (–).
3. Replace the cover.
If the range or effectiveness of the remote control decreases, replace
the batteries. Use two R6P(SUM-3)/AA(15F) type dry-cell batteries.
CAUTION:
Follow these precautions to avoid leaking or cracking cells:
Place batteries in the remote control so they match the polarity: (+)
to (+) and (–) to (–).
Use the correct type of batteries. Batteries that look similar may
differ in voltage.
Always replace both batteries at the same time.
Do not expose batteries to heat or flame.
Before Installation
General Precautions
DO NOT insert any metal object into the unit.
DO NOT disassemble the unit or remove screws, covers, or
cabinet.
DO NOT expose the unit to rain or moisture.
Locations
Install the unit in a location that is level and protected from
moisture.
The temperature around the unit must be between 23˚F and 95˚F
(–5˚C and 35˚C).
Make sure there is good ventilation around the unit. Poor
ventilation could cause overheating and damage the unit.
Handling the unit
DO NOT touch the power cord with wet hands.
DO NOT pull on the power cord to unplug the cord. When
unplugging the cord, always grasp the plug so as not to damage
the cord.
Keep the power cord away from the connecting cords and the
antenna. The power cord may cause noise or screen interference. It
is recommended to use a coaxial cable for antenna connection,
since it is well-shielded against interference.
When a power failure occurs, or when you unplug the power cord,
the preset settings such as preset FM/AM (MW/LW) channels and
sound adjustments may be erased in a few days.
Checking the Supplied Accessories
Check to be sure you have all of the following supplied accessories.
The number in the parentheses indicates the quantity of the pieces
supplied.
Remote Control (1)
Batteries (2)
AM (MW/LW) Loop Antenna (1)
FM Antenna (1)
If anything is missing, contact your dealer immediately.
Getting Started
EN01-09.RX-E100RSL[B]_f 01.3.8, 2:48 PM3
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC RX-E100RSL at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC RX-E100RSL in the language / languages: English as an attachment in your email.

The manual is 1,41 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of JVC RX-E100RSL

JVC RX-E100RSL User Manual - Dutch - 50 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info