663478
18
Zoom out
Zoom in
Previous page
1/72
Next page
ENGLISH
14
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
TROUBLESHOOTING INSTALLATION/CONNECTION
Warning
The unit can only be used with a 12V DC power supply, negative ground.
Disconnect the battery’s negative terminal before wiring and mounting.
Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or Ground wire
(black) to prevent a short circuit.
Insulate unconnected wires with vinyl tape to prevent a short circuit.
Be sure to ground this unit to the car’s chassis again after installation.
Caution
For safety’s sake, leave wiring and mounting to professionals. Consult the car audio dealer.
Install this unit in the console of your vehicle. Do not touch the metal parts of this unit during
and shortly after use of the unit. Metal parts such as the heat sink and enclosure become hot.
Do not connect the wires of speakers to the car chassis or Ground wire (black), or connect
them in parallel.
Connect speakers with a maximum power of more than 50W. If the maximum power of
the speakers is lower than 50W, change the
[AMP GAIN]
setting to avoid damaging the
speakers.
( 10)
Mount the unit at an angle of less than 30º.
If your vehicle wiring harness does not have the ignition terminal, connect Ignition wire (red)
to the terminal on the vehicle’s fuse box which provides 12 V DC power supply and is turned
on and off by the ignition key.
Keep all cables away from heat dissipate metal parts.
After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are
working properly.
If the fuse blows, first make sure the wires are not touching car’s chassis, then replace the old
fuse with one that has the same rating.
Basic procedure
1
Remove the key from the ignition switch, then disconnect the
[
terminal of the car
battery.
2
Connect the wires properly.
See Wiring connection.
( 16)
3
Install the unit to your car.
See Installing the unit (in-dash mounting).
( 15)
4
Connect the terminal of the car battery.
5
Reset the unit.
( 3)
Symptom Remedy
ANDROID
Sound cannot be heard
during playback.
Sound output only from
the Android device.
Reconnect the Android device.
If in
[AUDIO MODE]
, launch any media player
application on the Android device and start playback.
If in
[AUDIO MODE]
, relaunch the current media player
application or use another media player application.
Restart the Android device.
If this does not solve the problem, the connected Android
device is unable to route the audio signal to unit.
( 12)
Cannot playback at
[AUTO MODE]
.
Make sure JVC MUSIC PLAY APP is installed on the
Android device.
( 5)
Reconnect the Android device and select the appropriate
control mode.
( 6)
If this does not solve the problem, the connected Android
device does not support
[AUTO MODE]
.
( 12)
“NO DEVICE” or “READING”
keeps flashing.
Switch off the developer options on the Android device.
Reconnect the Android device.
If this does not solve the problem, the connected Android
device does not support
[AUTO MODE]
.
( 12)
Playback is intermittent or
sound skips.
Turn off the power saving mode on the Android device.
“CANNOT PLAY”
Make sure Android device contains playable audio files.
Reconnect the Android device.
Restart the Android device.
If you still have troubles, reset the unit.
( 3)
JS_JVC_KD-X241_E_EN_3.indd 14JS_JVC_KD-X241_E_EN_3.indd 14 8/30/2016 3:28:31 PM8/30/2016 3:28:31 PM
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC KD-X141 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC KD-X141 in the language / languages: English, German, French as an attachment in your email.

The manual is 1,34 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of JVC KD-X141

JVC KD-X141 User Manual - Dutch, Italian, Portuguese, Spanish - 72 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info