167150
28
Zoom out
Zoom in
Previous page
1/178
Next page
28
ENGLISH
To select the subwoofer cutoff frequency
WooferFreq (only for KD-LX333R)
When a subwoofer is connected to this unit,
select an appropriate cutoff frequency level for
your subwoofer. When shipped from the factory,
the subwoofer cutoff frequency is set to “FREQ
MID.
FREQ LOW: Frequencies higher than
50 Hz are cut off to the
subwoofer.
FREQ MID: Frequencies higher than
80 Hz are cut off to the
subwoofer.
FREQ HIGH: Frequencies higher than
120 Hz are cut off to the
subwoofer.
To adjust the line input level — LINE ADJ
(only for KD-LX333R)
Adjust the line input level properly when an
external component is connected to the LINE
INPUT plugs. When shipped from the factory, the
line input level is set at level “00.
If the input level of the connected component is
not high enough, increase the input level
properly. Without adjusting the line input level,
you may be surprised at a loud sound when you
change from the external component to another
source.
To select the external component to use
–– EXT INPUT (only for KD-LX111R)
You can connect the external component to the
CD changer jack on the rear using the Line Input
Adaptor KS-U57 (not supplied).
To use the external component as the playback
source through this unit, you need to select
which component – CD changer or external
component – to use. When shipped from the
factory, CD changer is selected as the external
component.
LINE INPUT: To use the external component
other than CD changer.
CD CHANGER:To use the CD changer.
Note:
For connecting the Line Input Adaptor KS-U57 and
the external component, refer to the Installation/
Connection Manual (separate volume).
To make the front panel look flat (hiding
the control panel) — FLAT PANEL
When operating the receiver using the remote
control, you can hide the control panel to make
the front panel look flat. When shipped from the
factory, “FLAT OFF” is selected.
FLAT ON: The control panel will not come
out when you turn on the unit.
To use the control panel, press
4 so that the control
panel comes out. If no
operation is done for about 10
seconds, it automatically goes
back into the receiver.
FLAT OFF: You can use the control panel
normally.
Note:
When “FLAT ON” is selected, you can eject a CD by
holding 4 .
To change the FM tuner selectivity
IF FILTER
In some areas, adjacent stations may interfere
with each other. If this interference occurs, noise
may be heard. This unit has been preset to
automatically reduce this interference noise
(“AUTO”) when shipped from the factory.
AUTO: When this type of interference
occurs, this unit automatically
increases the tuner selectivity
so that interference noise will
be reduced. (But the stereo
effect will also be lost.)
WIDE: Subject to the interference from
adjacent stations, but sound
quality will not be degraded
and the stereo effect will not be
lost.
EN25-33KD-LX333_111R[E]4.pm5 12/22/01, 6:21 PM28
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC kd lx111r at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC kd lx111r in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info