658629
62
Zoom out
Zoom in
Previous page
1/76
Next page
62 EN
DBS Receiver Multi-Brand
Remote Control
The VCR's remote control can control functions on the brands
of DBS (Direct Broadcast Satellite) receivers listed below.
TURN ON THE DBS
RECEIVER
1
Turn the power on using the DBS receivers remote
control.
SET REMOTE CONTROL
MODE
2
Set the VCR/TV/CABLE/DBS switch on the VCR’s
remote control to CABLE/DBS.
ENTER DBS RECEIVER BRAND
3
While holding down POWER on the VCR's remote
control, use the NUMBER keys to enter the DBS receiver
brand number from the chart below and then press STOP.
Follow the example shown at bottom left.
Once you have set the remote control to operate the
DBS receiver, you don't have to repeat this step until
you replace the remote control's batteries.
OPERATE DBS RECEIVER
4
First, press POWER to see if the DBS receivers power
goes off as it should. If it does, try other functions (TV
CH +/– and the NUMBER keys can be used to operate
the DBS receiver).
For some brands of DBS receiver, you must press
ENTER after having pressed the NUMBER keys.
To return the remote to VCR control, set the VCR/TV/
CABLE/DBS switch to VCR.
DBS BRAND NAME BRAND CODE
JVC (DISH Network) 51
ECHOSTAR (DISH Network) 51
PRIMESTAR 50
SONY (DSS) 41
RCA (DSS) 40
NOTES:
You must set the DBS receiver brand for your remote control
and the DBS receiver brand for your Controller (
Z
pg. 21)
separately.
Depending on the type of DBS receiver, there may be cases
where some or all functions cannot be operated using the
remote control.
It's not possible to operate a DBS receiver that is not
equipped with a remote control sensor.
Though ECHOSTAR has a number of different remote codes,
this remote control is applicable only to one of those codes
preset at the factory.
It's not possible to set the remote control for both your DBS
receiver and a cable box at the same time. You can only set
the remote control to operate one of these units at a time.
(Ex.) To set remote control to JVC 51:
Release
Hold down Press in succession
SPECIAL FEATURES (cont.)
123
456
7
89
0
2
4
1
3
POWER
STOP
ENTER
NUMBER
VCR/TV/CABLE/DBS
STOP
51
POWER
TV CH +
TV CH –
62


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC HR-S9500U at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC HR-S9500U in the language / languages: English as an attachment in your email.

The manual is 2,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info