57107
11
Zoom out
Zoom in
Previous page
1/37
Next page
(No.YA092B)1-11
SECTION 3
DISASSEMBLY
3.1 DISASSEMBLY PROCEDURE
Make sure that the power cord plug is pull out from the AC wall
outlet.
Wait until the LAMP UNIT has cool down is completely.
While not in repair service, place the chassis back its original
position.
<FRONT SIDE>
3.1.1 SPEAKER GRILL (L & R)
(1) Remove 1 screw [ A ] from right rear side.
(2) Remove 1 screw [ B ] from left rear side.
(3) Take out the SPEAKER GRILL (L& R).
3.1.2 SPEAKER
Take out the SPEAKER GRILL.
(1) Remove 4 screws [ C ].
(2) Take out the SPEAKER.
* Remove the both side SPEAKER same manner.
3.1.3 FRONT PANEL
Take out the SPEAKER GRILL.
(1) Remove 4 screws [ D ].
(2) Take out the FRONT PANEL.
3.1.4 LAMP COVER
Take out the SPEAKER GRILL of LEFT SIDE.
(1) Remove 1 screw [ E ].
(2) Take out the LAMP COVER.
NOTE :
Do not leave the LAMP COVER removed for long time to
prevent dirt and dust form covering the lens.
Make sure that the LAMP COVER is completely installed.
3.1.5 FRONT LED PWB
Take out the SPEAKER GRILL.
Take out the FRONT PANEL.
(1) Remove 2 screws [ F ] from rear side of FRONT PANEL.
(2) Take out the FRONT LED PWB.
3.1.6 FILTER COVER
Take out the SCREEN BLOCK.
(1) Remove 2 screws [ G ].
(2) Take out the FILTER COVER.
Remove the both side FILTER COVER same manner.
3.1.7 CENTER COVER
Take out the SPEAKER GRILL.
Take out the FRONT PANEL.
(1) Remove 2 screws [ H ].
(2) Take out the CENTER COVER.
3.1.8 SCREEN BLOCK
Take out the SPEAKER GRILL.
Take out the FRONT PANEL.
(1) Remove the 4 screws [ I ].
(2) Remove 10 screws [ J ] from rear side.
(3) Take out the SCREEN BLOCK.
CAUTION :
Place the SCREEN BLOCK on a flat table without fail.
Because of the large size, at least 2 parsons are
recommended for removal and reassemble.
Use care not to scratch the screen during work.
During assembly, be sure to engage the left and right tabs
with the cabinet mounting positions.
When supporting the SCREEN BLOCK, avoid grasping the
top of the screen panel, instead grasp the left and right
areas.
Do not leave the SCREEN BLOCK removed for long time
to prevent soiling from dust.
3.1.9 SCREEN ASS’Y
Take out the SCREEN BLOCK.
[HD-52Z575 / HD-52Z585]
(1) Remove 20 screws [ K ] from FRONT CABINET.
[HD-61Z575 / HD-61Z585]
(1) Remove 24 screws [ K ] from FRONT CABINET.
(2) Take out the SCREEN ASS’Y.
3.1.10 FRONT PANEL
Take out the SCREEN BLOCK.
[HD-52Z575 / HD-52Z585]
(1) Remove 16 screws [ L ] from FRONT CABINET.
[HD-61Z575 / HD-61Z585]
(1) Remove 20 screws [ L ] from FRONT CABINET.
(2) Take out the FRONT PANEL.
Masking
tape
IC2081
REAR JACK PWB
CAUTION AT DISASSEMBLY
Fig.1
Pay extra attention in the following matter when turning the
power on with the BODY COVER removed.
(1) Prior to disassembly, unplug the power cord from the AC
outlet without fail. (Turn the power "off".)
(2) Make sure that the REAR JACK PWB: IC2081 is
completely covered with black masking tape. (Fig.1)
(3) Make sure to remove the masking of REAR JACK:
IC2081 when attaching the BODY COVER.
(4) Do not turn the power on until the BODY COVER is
attached properly, after the masking is removed.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC HD-61Z585 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC HD-61Z585 in the language / languages: English as an attachment in your email.

The manual is 1,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info