57107
6
Zoom out
Zoom in
Previous page
1/37
Next page
1-6 (No.YA092B)
1.4 SERVICE PARTS KIT INSTRUCTIONS
Due to the character of this product, these OPTICAL /
DRIVE ASS’Y are prepared.
Please note these OPTICAL /DRIVE ASS’Y when
replacing or ordering the parts.
1.4.1 PART NUMBER AND CONSTRUCTION
1.4.2 OPTICAL / DRIVE ASS’Y CONSTRUCTION
(1) OPTICAL BLOCK
(Included HD-ILA DEVICE, PROJECTION LENS)
(2) OPTICAL BASE
(3) MAIN DRIVE PWB ASS’Y
This PWB is mounted with 2 memory ICs saved with
adjustment, setting data of the drive circuit.
(4) SHIELD TAPE
* The following parts are not included in the kit.
1) REMOTE SENSOR PWB ASS’Y
2) FAN CONTROL PWB ASS’Y
3) LAMP UNIT
4) FRONT SHADE BRACKET
5) SHADE COVER
1.4.3 PRECAUTION FOR USING
(1) In the case of the following defects/problems, replace this
kit (OPTICAL/DRIVE ASS'Y)
1) Picture defect caused by optical system/D-ILA device
related parts.
2) Picture defect caused by drive circuit.
(2) The MAIN DRIVE PWB ASSY is mounted with 2 memory
ICs [IC3741/IC3742] saved with adjustment/setting data
(GAMMA, SHADING, etc.) of the drive circuit.
The data of this memory IC is in the optimal state according
to individual D-ILA devices and each section of the
OPTICAL BLOCK.
(3) When replace the MAIN DRIVE PWB ASS’Y, take off the 2
memory ICs from the original board and replace with new
one. When replace the MAIN DRIVE PWB ASS’Y, do same
manner. Replace 2 memory ICs.
(4) When installing this kit (OPTICAL/DRIVE ASS'Y) to the
set, first mount the FRONT SHADE BRACKET and
SHADE COVER (with cushion) to the kit (lens section).
(5) After the replacement of the OPTICAL BLOCK, projection
lens focus adjustment and drive convergence / projection
adjustment are required.
1.5 SCREEN HANDLING CAUTIONS
1.5.1 SCREEN STORAGE
Store the SCREEN ASS'Y in a standing position in order to
avoid deformation. If the screen is stored horizontally, there is
risk of deforming the screen face.
When necessary to place the SCREEN ASS'Y horizontally,
position the screen side upwards and sure to place spacers
between the screen and resting site (floor or stand etc.) to
prevent the screen from sagging.
1.5.2 SCREEN SURFACE
Since the screen surface is easily scratched or soiled, use ample
care when handling.
1.5.3 PRECAUTIONS FOR CLEANING AND REPLACEMENT
The SCREEN ASS’Y is made from the lenticular lens and
fresnel lens.
The anti static proceeding and the surface of the lenticular lens.
Rubbing the surface with something hard, the coating may
peel off.
When the screen is dirty, gently wipe it with a soft cloth.
If the screen is very dirty, wipe it down with a cloth dipped in
a diluted kitchen cleaner (neutrality detergent) and
thoroughly wrung-out.
Then wipe immediately after with clean, dry cloth.
Never use the organic solvent such as the alcohol or benzine.
The SCREEN ASS’Y replacement is required if the coating
was peel off.
Alkaline detergent or acidity detergent can not be be used.
The notched side of the lenticular lens and the fresnel lens
are faced each other.
Do not rub the screen when cleaning it or replaceing it.
Rubbing the screen may cause of the scratch of the screen
by its notch.
Kit parts number Kit part name
TS-COP5A-SAA OPTICAL / DRIVE ASS’Y
OPTICAL / DRIVE ASS'Y : TS-COP5A-SAA
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC HD-61Z585 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC HD-61Z585 in the language / languages: English as an attachment in your email.

The manual is 1,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info