16
Introduction
Zoom Lens
(Supplied with GY-HM750U/GY-HM750E only)
A Focus Ring
B Zoom Lever/Ring
To operate zoom with this lever, turn the [ZOOM] switch M
and set it to AMANU.B.
C
Iris Ring
To operate auto iris, set the iris mode switch H to AAB.
D Lens Cable
E [REC] Record Trigger Button
Starts/stops recording.
F [RET] Return Video Button
Press this button to play back and check the latest clip,
according to the settings under [Clip Review] of [Switch Set]
in the [Camera Function] menu. (A Page 79)
( A Page 56 [Viewing Recorded Videos Immediately (Clip
Review)])
Memo :
When [LENS RET] of [Switch Set...] in the [Camera
Function] menu is set to AFocus AssistB, this button
functions as the Focus Assist button. When it is set to
AReturnB, a return video is displayed. (A Page 79)
G Zoom Servo Control Lever
To operate zoom servo with the zoom servo control lever, set
the [ZOOM] switch M to ASERVOB.
Zooms into wide angle and increases the angle of view
when AWB is pressed.
Zooms into telephoto and decreases the angle of view
when ATB is pressed.
Zoom speed increases when the lever is pressed hard.
H Iris Mode Switch
I Iris Momentary Button
Press and hold this button to change to auto iris mode when
the iris mode switch H is set at AMB.
J [I.G.] Iris Speed Adjustment Knob
If the speed is set too fast, opening/closing of the iris
becomes unstable and hunting may occur. Readjust the
speed in this case.
K Filter Built-In Screw
A transparent or UV filter for lens protection can be installed
inside the lens hood from the front. Filters for various effects
can also be used.
Installable filter types
L Zoom Servo Connector
For connecting a zoom servo unit (sold separately).
M [ZOOM] Zoom Switch
N Back Focus Ring/Lock Screw
Exclusive ring for adjusting the back focus. After adjusting,
secure with a lock screw.
( A Page 28 [Adjusting Back Focus])
O [M] Macro Focus Ring (for close-ups)
Turn the ring in the direction of the arrow to take close-up
shots of small objects.
Normal focusing and zooming cannot be performed in macro
mode.
To take macro shots
Set focus ring A to infinity (n).
Set zoom ring B to the maximum wide angle.
Rotate this ring in the direction of the arrow to adjust
focus on the object.
Note :
As the back focus knob is located nearby, be careful not to
mistake the two knobs.
Do not forget to restore the macro ring to its original
position after use. ( A Page 28 [Adjusting Back Focus])
Names of Parts (continued)
M
RET
IRIS
A M
W
T
REC
H
ABC
I
GFE
NL O
D
J
K
MANU.
SERVO
ZOOM
M
CANON KT14 x 4.4KRSJ
A
: Auto iris operation mode.
M
: Manual iris operation mode.
When installed on the hood : 82 mm P0.75
When installed on the lens body : 72 mm P0.75
SERVO
: Enables zooming with the zoom servo control
lever G.
MANU.
: Enables zooming with the zoom lever/ring B.
