46752
53
Zoom out
Zoom in
Previous page
1/64
Next page
EN 53
TROUBLESHOOTING
MasterPage: Start_Right
REFERENCES
Other problems
Charging is difficult in places subject to extremely
high/low temperatures.
HTo protect the battery, it is recommended to
charge it in places with a temperature of 10°C to
35°C. ( pg. 57)
The battery pack is not attached firmly.
HDetach the battery pack once again and re-attach
it firmly. ( pg. 13)
The date/time is not set.
HSet the date/time. ( pg. 15)
The built-in clock battery has run out and the
previously set date/time has been erased.
HConsult your nearest JVC dealer for replacement.
Files stored in the memory card are protected.
HRemove protection from the files stored in the
memory card and delete them. ( pg. 28)
This is not a malfunction.
HBy recording with “DIS” activated ( pg. 33, 34)
this can be avoided.
The DV cable was plugged/unplugged with power
turned on.
HTurn the camcorder’s power off and on again,
then operate it.
The VIDEO/MEMORY switch is set to
“MEMORY”.
HSet the VIDEO/MEMORY switch to “VIDEO”.
In places subject to low temperature, images
become dark due to the characteristics of the
LCD monitor. This is not a malfunction.
HAdjust the brightness and angle of the LCD
monitor. ( pg. 12, 16)
When the LCD monitor’s fluorescent light reaches
the end of its service life, images on the LCD
monitor become dark.
HConsult your nearest JVC dealer.
The LCD monitor is made with high-precision
technology. However, black spots or bright spots
of light (red, green or blue) may appear constantly
on the LCD monitor. These spots are not
recorded on the tape. This is not due to any
defect of the unit. (Effective dots: more than
99.99%)
The battery’s charge is low.
HInstall a fully charged battery. ( pg. 13)
HPush in the memory card a few more times.
( pg. 17)
The LCD monitor’s brightness setting is too dark.
HAdjust the brightness of the LCD monitor.
( pg. 16)
A malfunction of some kind has occured. In this
case the camcorder’s functions become
unusable.
H pg. 56.
“REMOTE” is set to “OFF”.
HSet “REMOTE” to “ON”. ( pg. 33, 35)
The remote control does not point at the remote
sensor.
HPoint at the remote sensor. ( pg. 23)
The remote control batteries are exhausted.
HReplace the batteries with fresh ones. ( pg. 23)
The POWER/CHARGE lamp on the camcorder
does not light during charging.
“SET DATE/TIME!” appears.
Files stored in the memory card cannot be
deleted.
When the image is printed from the printer, a
black bar appears at the bottom of the screen.
When the camcorder is connected via the DV
connector, the camcorder does not operate.
When connected to the PC with a DV cable, the
image data is not transferred.
Images on the LCD monitor appear dark or
whitish.
Coloured bright spots appear all over the LCD
monitor.
The cassette will not load properly.
The memory card cannot be removed from the
camcorder.
Picture does not appear on the LCD monitor.
An error indication (01 – 04 or 06) appears.
The remote control does not work.
GR-XASIA.book Page 53 Tuesday, April 12, 2005 8:52 PM
53


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC GR-X5AC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC GR-X5AC in the language / languages: English as an attachment in your email.

The manual is 5,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info