46752
13
Zoom out
Zoom in
Previous page
1/64
Next page
EN 13
GETTING STARTED
MasterPage: Start_Right
GETTING STARTED
This camcorder’s 2-way power supply system
lets you choose the most appropriate source of
power. Do not use provided power supply units
with other equipment.
Charging the Battery Pack
1 Set the power switch to “OFF”.
2 With the arrow on the battery pack pointing
upward, push the battery pack slightly against
the battery pack mount.
If the battery mount cover is attached, remove it
by sliding BATT. RELEASE.
3 Slide up the battery pack until it locks in
place.
4 Connect the AC adapter to the camcorder.
5 Connect the power cord to the AC adapter.
(AP-V14E, AP-V14AC only)
6 Plug the AC adapter into an AC outlet. The
POWER/CHARGE lamp on the camcorder
blinks to indicate charging has started.
7 When the POWER/CHARGE lamp goes out,
charging is finished. Unplug the AC adapter from
the AC outlet. Disconnect the AC adapter from
the camcorder.
To detach the battery pack
While sliding BATT. RELEASE, remove the
battery pack.
* Provided
NOTES:
This product includes patented and other
proprietary technology and will operate only
with JVC Data Battery. Use the JVC BN-
VF707U/VF714U/VF733U battery packs. Using
generic non-JVC batteries can cause damage
to the internal charging circuitry.
If the protective cap is attached to the battery
pack, remove it first.
Make sure to use the battery pack with the arrow
( ) mark. The camcorder does not turn on with the
battery mount cover without the arrow ( ) mark.
When charging the battery pack for the first time
or after a long storage period, the POWER/
CHARGE lamp may not light. In this case, remove
the battery pack from the camcorder, then try
charging again.
If the battery operation time remains extremely
short even after having been fully charged, the
battery is worn out and needs to be replaced.
Please purchase a new one.
Since the AC adapter processes electricity
internally, it becomes warm during use. Be sure to
use it only in well-ventilated areas.
Using the optional AA-VF7 battery charger, you
can charge the BN-VF707U/VF714U/VF733U
battery pack without the camcorder.
After 5 minutes has elapsed in record-standby
mode with the cassette inserted, the camcorder
will automatically turn off its power supplied from
the AC adapter. In this case, the battery charge
starts if the battery is attached to the camcorder.
Using the Battery Pack
Perform steps 23 in “Charging the Battery
Pack.
Maximum continuous recording time
* Provided
( ): When LCD backlight is off.
Power
A
POWER/CHARGE
Lamp
Battery pack
BATT. RELEASE
Open the cover.
Power Switch
mark
Arrow
Battery pack
mount
AC Adapter
(ex. AP-V17E)
To DC connector
To AC outlet
Battery pack Charging time
BN-VF707U* Approx. 1 hr. 30 min.
BN-VF714U Approx. 2 hr. 40 min.
BN-VF733U Approx. 5 hr. 40 min.
Battery pack Recording time
BN-VF707U* 45 min. (55 min.)
BN-VF714U
1 hr. 35 min. (1 hr. 55 min.)
BN-VF733U 3 hr. 45 min. (4 hr. 35 min.)
CONTINUED ON NEXT PAGE
GR-XASIA.book Page 13 Tuesday, April 12, 2005 8:52 PM
13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC GR-X5AC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC GR-X5AC in the language / languages: English as an attachment in your email.

The manual is 5,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info