39846
12
Zoom out
Zoom in
Previous page
1/60
Next page
EN
12
20
5
m
h
1h30m
1h29m
0h03m
1h30m
0h02m
0h01m
0h00m
P
L
A
Y
O
F
F
A
M
S
H
U
T
T
L
E
S
E
A
R
C
H
0
!
@
$
180°
90°
t
Q
5
During shooting
Basic Recording
Perform the procedures listed below before continuing.
Power ( pg. 7)
Grip Adjustment ( pg. 8)
Viewfinder Adjustment ( pg. 8)
Load A Cassette ( pg. 9)
Recording Mode Setting ( pg. 10)
1 Remove the lens cap.
Pull on bottom end Q of LCD monitor to open and set
the VIDEO/MEMORY Switch t to VIDEO.
2 Set the Power Switch @ to or while
pressing down the Lock Button $ located on the
switch.
Shooting while using the LCD monitor: Open the
LCD monitor fully.
Shooting while using the viewfinder: Pull out the
viewfinder fully.
The Power lamp 0 lights and the camcorder enters
the Record-Standby mode. PAUSE 8 is displayed.
The image will not appear simultaneously on the LCD
monitor and the viewfinder. See PRIORITY in the
SYSTEM Menu ( pg. 34).
3 Press the Recording Start/Stop Button !.
4, 8 appears and the tally lamp ^ lights while
recording is in progress.
To Stop Recording, press the Recording Start/Stop
Button !. The camcorder re-enters the Record-
Standby mode.
To Adjust The Brightness Of The Display
..... press MONITOR BRIGHT + or 5 until the bright
level indicator o on the display moves and the
appropriate brightness is reached.
It is also possible to adjust the brightness of the
viewfinder. Pull out the viewfinder, set PRIORITY in
the SYSTEM Menu to FINDER ( pg. 34) and
adjust as described above.
TAPE RECORDING
NOTES:
If the Record-Standby mode continues for 5 minutes, the
camcorders power shuts off automatically. To turn the
camcorder on again, push back and pull out the
viewfinder again or close and re-open the LCD monitor.
When a blank portion is left between recorded scenes on
the tape, the time code is interrupted and errors may
occur when editing the tape. To avoid this, refer to
RECORDING FROM THE MIDDLE OF A TAPE
(
pg. 14).
To turn the tally lamp
^ or beep sounds off,
pg. 34.
When you use the LCD monitor outdoors in direct
sunlight, the LCD monitor may be difficult to see. If this
happens, use the viewfinder instead.
Black spots or bright spots of light (red, green or blue)
may appear constantly on the LCD monitor or the
viewfinder (
pg. 47).
When the Recording Start/Stop button ! is pressed, it
may take a few seconds before actual recording starts.
4 starts rotating when the camcorder actually
starts recording.
The time required to calculate and display the remaining
tape length, and the accuracy of the calculation, may vary
according to the type of tape used.
TAPE END appears when the tape reaches its end, and
the power goes off automatically if left in this condition for
5 minutes. TAPE END also appears when a cassette at
its end is loaded.
Tape remaining time
indicator (Approximate)
Display
(Now calculating)
(Blinking)
(Blinking)
(Blinking)
01 DX300/100/95/75EK_EN 12-16 2/26/03, 7:12 PM12
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC GR-DX300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC GR-DX300 in the language / languages: English as an attachment in your email.

The manual is 1,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of JVC GR-DX300

JVC GR-DX300 User Manual - German - 60 pages

JVC GR-DX300 User Manual - Dutch - 60 pages

JVC GR-DX300 User Manual - Dutch - 60 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info