595791
52
Zoom out
Zoom in
Previous page
1/68
Next page
52 EN
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
TROUBLESHOOTING
1.
No power is supplied.
2.
SET DATE/TIME!
appears.
3.
Recording cannot be
performed.
4.
There is no picture.
5.
The focus does not adjust
automatically.
6.
The cassette will not load
properly.
7.
Snapshot mode cannot be
used.
8.
The color of Snapshot
looks strange.
1.
The power is not connected
properly.
The battery is dead.
2.
The date/time is not set.
The built-in clock battery
has run out and the
previously set date/time has
been erased.
3.
The tapes erase protection
tab is set to SAVE.
The Power Switch is set to
or OFF.
•“TAPE END appears.
The cassette holder cover is
open.
4.
The camcorder is not getting
power, or some other
malfunction exists.
5.
Focus is set to the Manual
mode.
The recording was done in a
dark place, or the contrast
was low.
The lens is dirty or covered
with condensation.
6.
The cassette is in the wrong
position.
The batterys charge is low.
7.
The Squeeze mode is
selected.
8.
The light source or the
subject does not include
white. Or there are various
different light sources
behind the subject.
The Sepia or Monotone
mode is activated.
1.
Connect the AC Adapter
securely ( pg. 8).
Replace the dead battery
with a fully charged one
( pg. 7, 8).
2.
Set the date/time
( pg. 10).
Consult your nearest JVC
dealer for replacement.
3.
Set the tapes erase
protection tab to REC
( pg. 11).
Set the Power Switch to
or ( pg. 15).
Replace with new cassette
( pg. 11).
Close the cassette holder
cover.
4.
Turn the camcorders power
off and on again
( pg. 15).
5.
Set Focus to the Auto mode
( pg. 28).
Clean the lens and check
the focus again ( pg. 57).
6.
Set it in the right position
( pg. 11).
Install a fully charged
battery ( pg. 7, 8).
7.
Disengage the Squeeze
mode ( pg. 33).
8.
Find a white subject and
compose your shot so that it
also appears in the frame
( pg. 23).
Turn off Sepia and Mono-
tone ( pg. 24, 25).
If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.
The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio,
etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery
pack, AC Adapter, etc.) and wait a few minutes; and then re-connect it and proceed as usual from the
beginning.
52


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC GR-DVL210 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC GR-DVL210 in the language / languages: English as an attachment in your email.

The manual is 2,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info