56727
42
Zoom out
Zoom in
Previous page
1/56
Next page
TROUBLESHOOTING
42 EN
MasterPage: Left
The DV cable was plugged/unplugged with power turned
on.
HTurn the camcorder’s power off and on again, then operate
it.
The light used to illuminate the LCD monitor causes it to
become hot.
HClose the LCD monitor to turn it off or set the Power Switch
to “OFF”, and let the unit cool down.
In places subject to low temperature, images become dark
due to the characteristics of the LCD monitor. When this
happens, the displayed colours differ from those that are
actually recorded. This is not a defect of the camcorder.
HAdjust the brightness and angle of the LCD monitor.
( pg. 9, 12)
When the LCD monitor’s fluorescent light reaches the end
of its service life, images on the LCD monitor become dark.
HConsult your nearest JVC dealer.
The LCD monitor and the viewfinder are made with high-
precision technology. However, black spots or bright spots
of light (red, green or blue) may appear constantly on the
LCD monitor or the viewfinder during recording or
playback. These spots are not recorded on the tape. This is
not due to any defect of the unit. (Effective dots: more than
99.99 %)
This may occur when the surface or the edge of the LCD
monitor is pressed.
The battery’s charge is low.
HInstall a fully charged battery. ( pg. 6, 7)
— (GR-D93/73 only) —
HPush in the memory card a few more times. ( pg. 10)
The viewfinder is pulled out and “PRIORITY” is set to
“FINDER”.
HPush the viewfinder back in or set “PRIORITY” to “LCD”.
( pg. 12, 24, 26)
The LCD monitor’s brightness setting is too dark.
HAdjust the brightness of the LCD monitor. ( pg. 9)
HIf the monitor is tilted upward 180 degrees, open the
monitor fully. ( pg. 12)
The speaker volume is too great.
HTurn the speaker volume down. ( pg. 14)
HWipe them gently with soft cloth. Wiping strongly can
cause damage. ( pg. 48) To clean the viewfinder, please
consult your nearest JVC dealer.
“TIME CODE” is set to “OFF”.
HSet “TIME CODE” to “ON”. ( pg. 24, 27, 28)
A malfunction of some kind has occurred. In this case the
camcorder’s functions become unusable.
H pg. 44.
A malfunction of some kind has occurred. In this case the
camcorder’s functions become unusable.
H pg. 44.
— (GR-D93/73/53 only) —
“REMOTE” is set to “OFF”.
HSet “REMOTE” to “ON”. ( pg. 24, 26)
The remote control does not point at the remote sensor.
HPoint at the remote sensor. ( pg. 15)
The remote control batteries are exhausted.
HReplace the batteries with fresh ones. ( pg. 15)
When the camcorder is connected via the DV
connector, the camcorder does not operate.
The rear of the LCD monitor is hot.
Images on the LCD monitor appear dark or whitish.
Coloured bright spots appear all over the LCD
monitor or the viewfinder.
The indicators and the image colour on the LCD
monitor are not clear.
The cassette will not load properly.
The memory card cannot be removed from the
camcorder.
Picture does not appear on the LCD monitor.
Images on the LCD monitor are jittery.
The LCD monitor, the viewfinder and the lens have
become dirty (ex. fingerprints).
Time code does not appear.
An error indication (E01, E02 or E06) appears.
An error indication (E03 or E04) appears.
The remote control does not work.
GR-D93PAL.book Page 42 Wednesday, October 29, 2003 9:36 AM
42


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC GR-D23 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC GR-D23 in the language / languages: English as an attachment in your email.

The manual is 3,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of JVC GR-D23

JVC GR-D23 User Manual - German - 56 pages

JVC GR-D23 User Manual - Dutch - 56 pages

JVC GR-D23 User Manual - French - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info