23033
69
Zoom out
Zoom in
Previous page
1/88
Next page
EN
ENEN
EN

$'
$'$'
$'
Master Page: Right-Heading0
TROUBLESHOOTING
If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.
Power
Video and D.S.C. Recording
The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio,
etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery
pack, AC Adapter, etc.) and wait a few minutes; and then re-connect it and proceed as usual from the
beginning.
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
1. No power is supplied. 1. The power is not connected
properly.
The battery is dead.
The LCD monitor is not open
fully or the viewfinder is not
pulled out when recording.
1. Connect the AC Adapter
securely. ( pg. 11)
Replace the dead battery
with a fully charged one.
( pg. 10, 11)
Open the LCD monitor fully
or pull out the viewfinder.
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
2. Recording cannot be
performed.
2. The Power Switch is set to
PLAY or OFF.
For Video Recording
The tapes erase protection
tab is set to SAVE.
The VIDEO/MEMORY
Switch is set to MEMORY.
•“TAPE END appears.
The cassette holder cover is
open.
For D.S.C. Recording
The VIDEO/MEMORY
Switch is set to VIDEO.
2. Set the Power Switch to A
or M. ( pg. 17, 23)
For Video Recording
Set the tapes erase
protection tab to REC.
( pg. 15)
Set the VIDEO/MEMORY
Switch to VIDEO.
Replace with new cassette.
( pg. 15)
Close the cassette holder
cover.
For D.S.C. Recording
Set the VIDEO/MEMORY
Switch to MEMORY.
3. When shooting a subject
illuminated by bright light,
vertical lines appear.
3. This is a result of exceedingly
high contrast, and is not a
malfunction.
3.
4. When the screen is under
direct sunlight during shooting,
the screen becomes red or
black for an instant.
4. This is not a malfunction. 4.
5. During recording, the date/
time does not appear.
5. •“DATE/TIME is set to OFF. 5. Set DATE/TIME to ON.
( pg. 31, 38)
6. During recording, sound
cannot be heard.
6. The is normal. 6.
7. The LCD monitor or
viewfinder indications blink.
7. Certain Wipe/Fader effects,
certain modes of Program AE
with special effects, DIS
and other functions that
cannot be used together are
selected at the same time.
7. Re-read the sections covering
Wipe/Fader effects, Program
AE with special effects and
DIS. ( pg. 31 34, 36)
CONTINUED ON NEXT PAGE
REFERENCES
GR-D200US.book Page 69 Friday, April 11, 2003 1:05 PM
69


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC GR-D200 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC GR-D200 in the language / languages: English as an attachment in your email.

The manual is 5,14 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of JVC GR-D200

JVC GR-D200 User Manual - German - 88 pages

JVC GR-D200 User Manual - Dutch - 88 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info