661767

Just Fire Double Duct EC10 Manual

9
Zoom out
Zoom in
Previous page
1/22
Next page
ENGLISH
2.INSTALLATION
2.4 FASTENING THE BRACKET(P6)
Drill the holes for anchoring the fastening bracket
to the wall using preferably the 6 holes showed in
black on the paper template. If the wall is not
sturdy enough it is advisable to use extra anchor
bolts using the holes showed in grey on the paper
template.
The anchor bolts provided require a 8mm holes;
the wall should be inspected to determine if
provided bolts are useful or if it is necessary to
use a different anchorage. The manufacturer
is not liable in case of underestimation of the
structural consistency of the anchorage made
at the time of installation.
2.5 INSTALLATION OF THE PIPES
(P20)
After drilling the holes, the plastic sheet supplied
with the air conditioner need to be fitted through
them.
Measure the depth of the wall and cut supplied
plastic sheet.
Roll the sheet and insert it into the hole, paying
attention to the joint line, which must be always
upper position. Remember that the sheet must
0
have the same inclination of the holes(min 3 ).
Insert the rings into the holes.
7
System “B”: in case of impossibility to install the
drainage pipa as showed on “A” system, please
use system “B” to drain the condensate moisture
to a suitable place.
If use system “B”, please do not unplug the black
rubber cup from system “A”.
Usually “B” hole is used in the installation when
the outside temperature is very low, and in this
way we prevent no ice in the discharge water
pipe. This solution is used also to be more easy
for the installer to connect the internal drainage
pipe when he don’t want to see the pipe from
outside.
P6
P20
150mm ring
160mm ring
… 9 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Just Fire Double Duct EC10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Just Fire Double Duct EC10 in the language / languages: English as an attachment in your email.

The manual is 15,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info