18
14.10 Empty system
This procedure is necessary to prevent your machine from
frost damage while being transported.
Ⅲ Put a container under the pivoting nozzle (20).
Ⅲ Press selector key and remove water tank
Ⅲ STEAM INTAKE
Ⅲ PRESS STEAM / FILL SYSTEM
Ⅲ Switch off machine by pressing ON/OFF key .
15. Cleaning
The machine has an integrated cleaning program. The procedure
lasts about 15 minutes.
Jura cleaning tablets which are specially designed for the
cleaning program of your IMPRESSA are available at your
authorized dealer. Please note that machine defects or
residues in the water cannot be excluded if you use inappro-
priate cleaning agents.
It is essential not to interrupt the process once it has been
started.
Ⅲ Switch on your machine by pressing ON/OFF key
Ⅲ Press key until you can hear an acoustic signal.
Ⅲ EMPTY TRAY (FILL WATER might show as well)
Put a sufficiently large container under the coffee-spout (15)
in order to prevent cleaning liquid from running into the drip
tray.
Ⅲ ADD TABLET (Fig. 9) / PRESS CLEANING
Ⅲ UNIT CLEANING / PLEASE WAIT
Ⅲ EMPTY TRAY
Ⅲ PLEASE WAIT
Ⅲ RINSE UNIT
Ⅲ COFFEE READY
The powder funnel for pre-ground coffee should be cleaned
after each cleaning process. Remove it from the machine,
rinse it with hot tap water and replace it after drying.
16. Decalcifying
Your machine has an integrated decalcifying program. It lasts
approx. 50 minutes.
Jura de-scaling tablets which are specially designed for the
de-scaling program of your IMPRESSA S90/S95/S9/701/601
are available at your authorized dealer. Please note that
machine defects or residues in the water cannot be excluded
if you use inappropriate de-scaling agents.
Run the decalcifying program only after the machine has
been switched off for at least 5 hours and has cooled down
completely. The running decalcifying program must not be
interrupted.
If using acidic decalcifying agents be sure to immediately re-
move any splashes and drops from delicate surfaces, especi-
ally natural stone and wooden surfaces, or take correspond-
ing precautions.
In any case please wait until the filled decalcifying agent is
used up and the tank is empty. Never top up the decalcifying
agent.
Ⅲ Remove and empty water tank.
Ⅲ Replace empty water tank.
Ⅲ Switch off your machine by pressing ON/OFF key and let it
cool down for approx. 5 hours.
