12
11.8 Regular servicing
Regular Jura services ensure your machine’s reliability and longer
life. Keep the original packaging to protect the machine when it is
transported.
11.9 Empty system
Important: This process is necessary to protect the machine
from frost damages while being transported.
Ⅲ Press button to switch off the machine.
Ⅲ Place a container under the pivoting nozzle (13)
Ⅲ Turn selector switch for hot-water/steam (12) to position .
Ⅲ Press button to switch on the machine. Warning lamps ,
, , flash.
Ⅲ Press button until only warning lamp flashes. Steam
comes out after a short time.
Ⅲ Draw off steam until it stops automatically.
Ⅲ Turn selector button for hot-water/steam (12) back to position
.
12. Cleaning
The machine has an integrated cleaning program.
Note: Whenever the machine needs cleaning, warning lamp
lights up. You can still draw off coffee and hot-water/
steam and run the cleaning program later.
Only use Jura cleaning tablets. These are available from your
Jura dealer.
Important: It is essential not to interrupt the process once it
has been started.
11.5 Machine furred
Your machine will become furred in the course of normal use. The
amount of furring depends on the hardness of your water. The ma-
chine registers when descalcifying becomes necessary and signals
this via warning lamp . You can still draw off coffee and hot-wa-
ter/ steam. However we recommend that you decalcify the machine
(as described in chapter 13) within the next few days. Warning
lamp does not go out until the complete decalcifying process has
been carried out.
11.6 Use of Claris filter cartridges
At the correct use of Claris filter cartridges, decalcifying of the
machine becomes unnecessary. For further information, please read
the instructions for use attached to the water tank.
Note: Furring display must be switched off (as described in
chapter 3.6) before using Claris filter cartridges.
11.7 General cleaning instructions
Ⅲ Never use sharp or abrasive articles or corrosive chemicals to
clean your machine.
Ⅲ Wipe down the casing inside and out using a soft damp cloth.
Ⅲ Clean the pivoting hot-water/steam nozzle every time it is used.
Ⅲ After warming milk, draw off a little hot-water to clean the
pivoting nozzle inside.
Ⅲ You can take off the pivoting nozzle for a thorough cleaning
(Fig. 8).
Ⅲ The water tank should be rinsed out and filled with clean water
daily.
Note: If you notice any furring in the water tank, this can be
descalcified separately with a customary decalcifying pro-
duct. Remove the tank from the machine in order to do this.
