32
2 Preparation
2 Preparation
E While a speciality coffee is being prepared,
you can stop preparation at any time. Simply
touch the symbol for the product in
question.
E Before and during the grinding operation
you can select the coffee strength for
ristretto Y, espresso < and coffee >:
‘normal’ (;), ‘strong’ (_).
The machine always uses the preset amount of
water for the type of coffee in question. You can
change this setting (see Chapter 2 ‘Preparation –
Permanently setting the amount of water for the
cup size’).
Your ENA features an energy-saving mode: Soon
after the last preparation, the ENA stops heating
up. To indicate that the machine is in energy-
saving mode, after about 5 minutes the brightness
of all the symbols is reduced. The ENA must heat
back up before the next preparation.
Coffee tastes best served hot. A cold porcelain cup
cools the beverage – and impairs the taste. We
therefore recommend prewarming the cups. The
full coffee aroma can develop only in prewarmed
cups. You can purchase a JURA cup warmer from
your specialised dealer.
Ristretto, espresso and coffee
Ristretto Y, espresso < and coffee > are all
prepared following this model.
Example:Proceed as follows to prepare one coffee.
Precondition:Your ENA is ready for use.
T Place a cup under the coffee spout.
> T Touch the Coffee symbol to start prepara-
tion.
The coffee symbol > and coffee strength
symbol (; or _) flash, the preset amount of
water flows into the cup.
Preparation stops automatically. Your ENA is
once more ready for use.
Permanently setting the amount of water
for the cup size
It is easy to make permanent settings for the
amount of water for all speciality coffees according
to the cup size. Adjust the amount once as shown
in the following example. Every time you prepare a
drink in the future, this amount of water will be
dispensed.
Example:Permanently adjust the amount of
espresso to the cup size.
Precondition:Your ENA is ready for use.
T Place a cup under the dual spout.
< T Touch the Espresso symbol for about
3 seconds until the RistrettoY and
coffee> symbols appear again.
< T Release the Espresso symbol.
The espresso is prepared. The Espresso
symbol< and coffee strength symbol
(; or _) are flashing.
< T Touch the Espresso symbol as soon as there
is enough espresso in the cup.
Preparation stops. The amount of water for
one espresso is permanently stored.
The Espresso symbol < and coffee strength
symbol (; or _) flash until the machine is
ready for use again.
E You can alter this setting at any time by
repeating the above procedure.
Ground coffee
You can choose to use a second coffee variety, for
example decaffeinated coffee, with the powder
chute for ground coffee.
E Use ground coffee which is not ground too
finely. Very fine coffee can block up the
system so that the coffee only comes out in
drips.
E Never add more than one level measuring
spoon of ground coffee.
