697300

Junkers CR 10 Manual

47
Zoom out
Zoom in
Previous page
1/84
Next page
47
Informations pour le professionnel
CR10 – 6 720 809 872 (2014/03)
6 Informations pour le professionnel
6.1 Installation
Installation murale
▶ Choisir un lieu d'installation approprié sur une paroi plane ( fig. 1, page 81).
▶ Monter le module de commande ( fig. 2 et 3, page 81).
Raccordement électrique
Le module de commande est alimenté en énergie par le câble BUS.
▶ Respecter la distance minimale (100 mm) entre les différents participants BUS.
▶ Utiliser au moins un câble de type H05 VV (NYM-J...).
▶ En cas d’influences inductives externes (par ex. installations PV), les câbles
doivent être blindés (par ex. LiYCY) et mis à la terre unilatéralement. Raccorder
le blindage à la mise à la terre de la maison, par ex. borne libre du conducteur de
protection ou conduite d’eau.
▶ Poser séparément les câbles basse tension et les câbles avec la tension de
réseau (distance minimale 100 mm).
▶ Si les sections des conducteurs ne sont pas les mêmes : utiliser la boîte de distri-
bution pour relier les participants BUS.
Longueur totale maximale des connexions BUS :
• ≤ 100 m avec section de conducteur = 0,50 mm
2
• ≤ 300 m avec section de conducteur = 1,50 mm
2
▶ Etablir la connexion BUS ( fig. 4, page 82)
6.2 Mise en service
Les tableaux suivants représentent la première mise en service ou la mise en service
du module de commande après une réinitialisation.
Installations avec un circuit de chauffe (régulateur d'ambiance)
▶ Mettre l’installation sous tension / reset CR10.
D’autres réglages ne sont pas nécessaires. La température
ambiante s’affiche.
°C
°F
… 47 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Junkers CR 10 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Junkers CR 10 in the language / languages: German, Dutch, French, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 3,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info