636912

Junker JC40FA31 Manual

38
Zoom out
Zoom in
Previous page
1/82
Next page
en
38
Fault Possible cause Remedial action
Temperature display
indicates “E..”.
Electronics have detected
a fault.
Call customer service.
The “cool-fresh”
compartment is too warm or
too cold.
The standard setting has
been set too high or too low
(e.g. if there is frost
in the “cool-fresh”
compartment).
The temperature in the “cool-fresh”
compartment can be set to be 3 steps warmer
and/or colder, Fig. ". If the temperature in the
refrigerator compartment is set to 0, the
temperature in the “cool-fresh” compartment
is almost 0 °C.
Note
A change to the standard setting will affect the
temperature in the refrigerator compartment
and freezer compartment.
1. Hold down “super” button 2 for 3 seconds
until temperature display 4 flashes.
2. Change the setting using the temperature
setting button 3.
Setting -3 corresponds to the coldest
setting
Setting +3 corresponds to the warmest
setting
The selected setting is saved after one
minute.
Appliance is not cooling,
temperature display and light
are lit.
Showroom mode is
switched on.
Hold down alarm button, Fig "/5, for
10 seconds until an acknowledgement signal
sounds.
After a short time check whether your
appliance is cooling.
The light does not function. The LED light is defective. See chapter “Light (LED)” section.
Appliance was open too
long.
Light is switched off after
approx. 10 min.
When the appliance is closed and opened,
the light is on again.
… 38 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Junker JC40FA31 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Junker JC40FA31 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info