Manual Junker JB33UK50 (page 69 of 72) (English, German, Dutch, French)

636802

Zoom out

Zoom in

1/72

Faults and repairs

In the event of a fault, check the tips in the following table

before calling the after-sales service.

: Risk of electric shock!

■ Work on the appliance electronics may only be performed by

a specialist.

■ Always disconnect the appliance from the power supply

when work is carried out on the electronics. Switch off the

circuit breaker or remove the fuse from your household fuse

box.

Replacing the oven light bulb

Replace faulty oven light bulbs.

You can obtain replacement light bulbs from customer service

or specialist retailers: E14, 220 - 240 V, 40 W, heat resistant to

300 °C. Only use these oven light bulbs.

: Risk of electric shock !

Disconnect the appliance from the power supply. Switch off the

circuit breaker or remove the fuse from the household fuse box.

1. Place a tea towel in the cold cooking compartment to prevent

damage.

2. Turn the glass cover anticlockwise and remove it.

3. Replace the oven light bulb with a bulb of the same type.

4. Screw on the glass cover again.

5. Remove the tea towel and switch on the circuit breaker.

Note: If the glass cover cannot be unscrewed: use rubber

gloves to turn it. You can order a special removal tool through

the after-sales service (order no. 613634)

Changing the door seal

If the door seal is defective, it must be replaced. Replacement

seals for your appliance can be obtained from the after-sales

service.

The door seal is attached in four places (figure A). When

replacing it, disconnect and attach the hooks at all four points

(figure B).

Check again to ensure that the seal is seated correctly in the

corners in particular.

After-sales service

In the event of faults and repairs that you cannot rectify yourself,

please use our after-sales service.

You can find the addresses in the after-sales service directory.

Note: You will be charged for calling the after-sales service

regarding an operating error.

When contacting the after-sales service, please specify the E-

number and FD number.

You can find these on the rating plate behind the appliance

door on the left-hand bottom edge.

Problem Possible cause Remedial action

Electrical operation is faulty (e.g. indicator

lamps no longer light up)

Fuse defective Check fuses in the fuse box and replace if

necessary

Liquid or runny dough runs to one side Appliance not installed level Check the appliance installation (see the

Installation instructions)

‹:‹‹ flashes in the clock display

There was a power cut Reset the time of day (see

section: Electronic clock)

Electronically controlled functions are mal-

functioning

Energy surges (e.g. lightning strike) Reset the function concerned

Smoke is generated during roasting or

grilling

Fat is burning on the grill element Continue grilling or roasting until the fat on

the grill element is burnt away

Wire rack or universal pan inserted incor-

rectly

Check the shelf heights (see section:

Roasting or grilling)

High levels of condensation are generated

in the cooking compartment

Normal occurrence (e.g. when baking

cakes with very moist toppings or roasting

a large joint)

Open the appliance door briefly from time

to time during operation

Enamelled accessories have matt, light-

coloured marks

Normal occurrence caused by dripping

meat or fruit juices

Not possible

Door panels are misted up Normal occurrence caused by tempera-

ture differences

Heat the appliance up to 100 °C and then

switch off again after 5 minutes

E no. FD no.

$ %

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Junker JB33UK50 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 3,97 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Junker JB33UK50 Manual

Product: