614765
16
Zoom out
Zoom in
Previous page
1/44
Next page
10
Operation and function / Operación y función
Opération et fonction / Messa in servizio della macchina
Overlocking width selection knob (for overlocking or roll hemming)
* Turn the handweel until the needles are fully raised.
• For overlocking
Push the overlocking width selection knob back so that it aligns with the rear red marking on the
throat plate.
• For roll hemming
1. Pull the overlocking width selection knob forward so that it aligns with the front red marking on
the throat plate.
2. Set the lower knife adjusting knob at “1 - 2”.
Perilla de ajuste de anchura de sobreorillado (para sobreorillado o dobladillado)
* Gire el volante de mano hasta que las agujas queden completamente elevadas.
• Para sobreorillado
Accione hacia atrás la perilla de ajuste de anchura de sobreorillado de modo que quede
alineada con la marca roja en la parte posterior en la placa de agujas.
• Para dobladillados de enrollado
1. Accione hacia adelante la perilla de ajuste de anchura de sobreorillado de modo que quede
alineada con la marca roja de la parte frontal en la placa de agujas.
2. Posicione en “1 - 2” la perilla de ajuste del cuchillo inferior.
Sélecteur de largeur d’overlock (pour coutures overlock ou roulottées)
* Tourner le volant jusqu’à ce que les aiguilles soient dans leur position la plus élevée.
• Pour les coutures overlock
Pousser le sélecteur vers l’arrière de façon à ce qu’il vienne dans l’alignement du repère
arrière rouge de la plaque à aiguilles.
• Pour coutures roulottées
1. Tirer le sélecteur vers l’avant de façon à ce qu’il vienne dans l’alignement du repère avant
rouge de la plaque à aiguilles.
2. Régler le sélecteur de position du couteau inférieur sur “1 - 2”.
Manopola per la selezione dell'ampiezza del sopraggitto (per cuciture di orlo
arrotolato)
* Ruotare il volantino della macchina sino a che gli aghi raggiungono la posizione tutta alta.
• Per cuciture sopraggitto
Premere la leva indietro sino a che sia allineata alla linea di riferimento rossa posteriore sulla placca
ago.
• Per orlo arrotolato
1. Premere la leva in avanti sino a che sia allineata alla linea rossa anteriore di riferimento sulla placca.
2. Regolare la manopola per la regolazione del coltello inferiore su "1 - 2".
Presser foot pressure adjusting screw
Pressure of the presser foot has been factory-adjusted properly. Therefore you do not need to
adjust it except when sewing a special material.
• To increase the pressure of the presser foot: For heavy-weight materials such as denim, tweed,
or hard linen.
• To decrease the pressure of the presser foot: For light-weight materials such as georgette,
lawn,or tricot.
(A) Standard position: The place where the lower part of control cap aligns with the upper face of cover.
Tornillo de ajuste de la presión del pie prensatelas
La presión del pie prensatelas ha sido ajustada adecuadamente en la fábrica. Por consiguiente,
used no necesita hacer nuevos ajustes a no ser para coser materiales especiales.
• Para aumentar la presión del pie prensatelas: Para materiales pesados tales como mezelillas.
paños asargados o telas duras.
• Para disminuir la presión del pie prensatelas: Para materiales ligeros como crespón georgete.
linón o tricot.
(A) Posición estándar: Cuando la parte inferior del botón de control se alinea con la cara superior
de la cubierta.
Vis de réglage de la pression du pied presseur
La pression du pied presseur a été réglée en usine pour un type d’étoffe ordinaire. En principe la
pression du pied presseur ne sera modifiée que pour les étoffes spéciales.
Augmenter la pression du pied presseur: pour les étoffes lourdes telles que denim, tweed, ou lin fort.
• Diminuer la pression du pied presseur: pour les étoffes légères telles que georgette, batiste ou tricot.
(A) Position standard: Lorsque la partie inférieure bu bouton de commande est dans l’alignement
du couvercle supérieur.
Vite di regolazione per la pressione del piedino
La pressione del piedino è già regolata per un trasporto ottimale. Per questo non è necessaria la
regolazione, ad eccezione che per cuciture su materiali speciali.
• Per aumentare la pressione del piedino: Per tessuti pesanti, come denim, tweed o lino pesante.
• Per diminuire la pressione del piedino: Per tessuti leggeri, come georgette, maglieria o tricot.
(A) Posizione standard: E' la posizione in cui la parte inferiore della manopola di regolazione sia
allineata con la parte superiore del carter (A).
Increase
Aumentar
Augmenter
Aumento
Decrease
Disminuir
Diminuer
Diminuzione
A
16


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Juki MO-654DE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Juki MO-654DE in the language / languages: English, French, Italian, Spanish as an attachment in your email.

The manual is 1,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Juki MO-654DE

Juki MO-654DE User Manual - German, Dutch - 42 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info