614766
32
Zoom out
Zoom in
Previous page
1/44
Next page
24
Sewing in tape
The standard presser foot is equipped with a tape guide. When sewing shoulders
or side seams of stretchy fabrics as a knitted fabric, a tape works effectively to
prevent undesirable stretch of the fabric.
1. Turn the handwheel toward you until the needles are fully raised.
2. Raise the presser foot, place the tape in the groove on the presser foot, and
lower the presser foot.
3. Loosen the guide adjusting screw (A) to fit the tape guide (B) to the tape width,
then tighten the screw.
4. Turn the handwheel manually to make two or three stitches in the tape.
5. Place the fabric to be sewn under the presser foot.
6. Sew, guiding the tape lightly.
Cosido en cinta
El prensatelas normal está equipado con una guía cinta. Cuando cosa hombros
o costuras laterales de telas elásticas, tales como prendas de punto, una cinta
contribuye a evitar estirados indeseables de la tela.
1. Gire hacia usted el volante de mano hasta que las agujas queden en la posición
más alta.
2. Eleve el pie prensatelas, coloque la cinta en la ranura en el pie prensatelas y
acciónelo hacia abajo.
3. Afloje el tornillo de ajaste de la guía (A) para que la guía de la cinta (B) se
acomode a la anchura de la misma: luego apriete dicho tornillo.
4. Gire el volante de mano para coser dos o tres puntadas en la cinta.
5. Coloque el material a coser debajo del pie prensatelas.
6. Cosa guiando la cinta suavemente.
Pose de bande de renfort
Le pied presseur standard est équipé d’un guide pour bande de renfort.
La bande de renfort permet de soutenir la couture des épaules ou des bordures
sur des tissus à maille et d’éviter ainsi les fronces indésirables.
1. Tourner le volant vers l’avant et amener les aiguilles dans leur position la plus
haute.
2. Relever le pied presseur, mettre la bande de renfort dans la fente du pied
presseur. Abaisser le pied presseur.
3. Desserrer la vis de réglage du guide (A) pour l’adapter le guide (B) à la largeur
de la bande. Resserrer la vis.
4. Faire 2 ou 3 points d’essai en tournant le volant à la main.
5. Mettre l’étoffe sous le pied presseur.
6. Piquer en guidant légèrement la bande.
Applicazione di un un nastro
Il piedino standard è dotato di una guida passanastro. Durante la cucitura si può
attaccare contemporaneamente un nastro o un elastico di una larghezza fino a 9
mm.
Il nastro è ideale per rinforzare le cuciture orizzontali in materiale di maglia (spalle)
o per attaccare un elastico lungo il bordo di taglio.
1. Portare gli aghi tutti in alto.
2. Alzare il piedino e girarlo. Passare il nastro sotto il piedino ed inserirlo da destra
nella guida nel piedino. Riportare il piedino diritto e abbassarlo.
3. Allentare la vite (A) di regolazione ed adattare la guida alla larghezza del nastro
(B), quindi stringere la vite.
4. Ruotare il volantino manualmente sino a formare due o tre punti sul nastro.
5. Posizionare il tessuto da cucire sotto il piedino.
6. Cucire aiutando l'inserimento del nastro con delicatezza.
Sewing in tape / Cosido en cinta
Pose de bande de renfort / Applicazione di un nastro
B
A
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Juki MO-644D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Juki MO-644D in the language / languages: English, French, Italian, Spanish as an attachment in your email.

The manual is 1,5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Juki MO-644D

Juki MO-644D User Manual - German, Dutch - 42 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info